| | |
| | IMG-296883 |
|
| | Preparations Applies to cars with a tow hitch |
| | IMG-286463 |
|
| | |
| | IMG-286465 |
|
| | |
| | IMG-296884 |
|
| | Only applies to USA tow hitches |
| | IMG-296885 |
|
| | |
| | IMG-286485 |
|
| | |
| | IMG-271804 |
|
| | |
| | IMG-323423 |
|
| | Take the cradle from the kit. Drill out three holes, using a Ø6 mm (15/64") drill bit, in the center of the three central drill markings (in the recessed holes) in the middle of the cradle. Remove any swarf and clean the edges of the holes.
|
| | IMG-286905 |
|
| | Drill six holes using Ø5 mm (13/64") drill bit, in the center of the six drill markings at the sides (in the recessed holes) on the cradle. Remove any swarf and clean the edges of the holes.
|
| | |
| | IMG-271806 |
|
| | |
| | IMG-296903 |
|
| | |
| | IMG-296943 |
|
| | |
| | IMG-271807 |
|
| | IMG-286923 |
|
| | Illustration A Illustration B Check that measurement A is 6.0 - 6.5 mm (15/64" - 1/4" ) between the upper edge on the mounting hook and the start of the radius for the bumper cover embossing on both sides. Adjust the measurement if necessary by carefully detaching the cradle and adjusting the measurement. Press the entire cradle securely.
Note!
It is important that the cradle is secured along its entire length, so that no bulges occur when riveting. |
|
| | IMG-297006 |
|
| | |
| | IMG-297007 |
|
| | Check that measurement A is 6.0 - 6.5 mm (15/64" - 1/4") between the upper edge of the holder and the start of the radius for the bumper cover embossing at the outer end. Press the cradle's outer end securely. Repeat points 13 and 14 for the other outer end.
Note!
It is important that the cradle is secured along its entire length, so that no bulges occur on the cradle when riveting. |
|
| | IMG-323424 |
|
| | Drill out three holes in the middle of the cradle using a Ø6 mm (15/64") drill bit through the pre-drilled holes and the bumper cover. Remove any swarf and clean the edges of the holes. Use a feeler gauge to remove any swarf from the rear of the cradle.
|
| | IMG-297023 |
|
| | |
| | IMG-286925 |
|
| | Drill out three holes at the sides of the cradle using a Ø5 mm (13/64") drill bit. Drill through pre-drilled holes and the bumper cover. Remove any swarf and clean the edges of the holes. Use a feeler gauge to remove any swarf from the rear of the cradle. Remove the fixtures.
|
| | IMG-297024 |
|
| | |
| | IMG-297025 |
|
| | |
| | IMG-271810 |
|
| | Depress the upper edge of the skid plate into the cradle (1). A click should be heard. Angle in the lower edge (2) towards the bumper cover. Install new plastic clips (3) and tighten.
|
| | IMG-271811 |
|
| | Note!
Ensure that the outer ends of the panel that are to be riveted are securely against the bumper cover when the holes are drilled. |
|
| | IMG-271812 |
|
| | |