Work is carried out in the same way on left and right-hand drive vehicles.

• Turn the ignition key to position 0.

Applies to vehicles where LEDs are to be replaced

• Carefully bend loose the diode/sensor in the instrument panel.

• Unplug the connector from the LED and move aside.

• Get the new LED. Connect it to the connector and install it by pressing it in the instrument panel.

• Remove air baffle.

• Remove the clips.

• Disconnect the washer hose.

• Take a piece of wiper hose. Tie a knot in it and install on the washer pump to prevent the washer fluid container from emptying.

Illustrations A and B

• Disconnect the washer hose.

• Tape the hose high up on the washer fluid container to prevent washer fluid from running out.

• Remove the screws in the hood lock and pull forwards.

• Disconnect the bonnet lock cable.

• Place the bonnet lock to one side. A new one can be found in the kit.

• Release the cradle and pull it back to make room for the bonnet lock cable.

Image A, B, C, D and E

• Take a new bonnet lock from the kit.

• Insert the cable as illustrated and route it to the newly detached cradle on the left-hand side of the headlamp.

• Press the connector into the existing hole.

• Connect the pre-routed connector to the routed cable. Found in the connection to the location.

• Disconnect the connector from its cradle.

• Remove the cradle with clips, they will not be reused.

• Install the bracket with siren.

• Tighten and torque tighten.

• Connect the siren.

Illustrations A and B

• Download software (application) for the accessory's function according to service information in VIDA. See VIDA or accessories catalogue for article number on software.