Sill decor - XC90 2011 - Volvo Cars Accessories

Installation instructions, accessories

Volvo Car Corporation Gothenburg, Sweden

XC90 2011

XC90 (03-) 2011

Instruction No		Version		Part. No.
31213819		1.2		31378095, 31213816

Sill decor

IMG-265384

Equipment

A0000162

IMG-239660

IMG-239664

IMG-265383

INTRODUCTION

Read through all of the instructions before starting installation.
Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.
Ensure that all tools stated in the instructions are available before starting installation.
Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.
In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

Preparations

IMG-265385

Preparations

IMG-265386

Drill out the pop rivet at the rear edge of the door sill panel and the rear pop rivet in the wing extender. Use a Ø6 mm (15/64") drill bit.
Remove any swarf and rivet residue.

IMG-265387

Carefully turn out the lower edge/rear edge of the front end of the wing extender.

Note!
Do not turn excessively so that the tape at the front edge detaches.
Remove the clip holding the rear end of the door sill panel.

IMG-265388

Drill out the pop rivets at the front edge of the door sill panel and in the rear edge of the wing extender. Use a Ø6 mm (15/64") drill bit.
Remove any swarf and rivet residue.

IMG-265389

Carefully turn out the lower edge/rear edge of the wing extender to make room to saw off the pin in the lower edge of the panel on the inside.

Note!
Do not turn excessively so that the tape at the front edge detaches.
Carefully cut off the pin on the panel. Use part of a hacksaw blade.

IMG-265390

Drill out the central pins in the clips at the lower edge of the door sill panel and remove them. Use a Ø4.5 mm (11/64")

IMG-265391

IMG-265392

Insert a large flat-bladed screwdriver, press the bottom of the clips and pull off the door sill panel with the clips.

IMG-265393

IMG-265394

Installation

IMG-265395

Installation

Take a new panel from the kit. Cut off the mounting eyelets on top of the upper sides.

IMG-265396

IMG-265397

IMG-265398

IMG-265399

Align the door sill panel ends under the wing extenders.
Press the front section clips into place.
Press the panel with the rubber strip along the body side. Ensure that all clips engage and that the rubber strip is correctly positioned.