Information

• Read through all of the instructions before starting installation.

• Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

• Ensure that all tools stated in the instructions are available before starting installation.

• Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

• In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

Color symbols

1. Used for focused component, the component with which you will do something.

2. Used as extra colors when you need to show or differentiate additional parts.

3. Used for attachments that are to be removed/installed. May be screws, clips, connectors, etc.

4. Used when the component is not fully removed from the vehicle but only hung to the side.

5. Used for standard tools and special tools.

6. Used as background color for vehicle components.

This instruction covers a Plug-In Hybride vehicle.

This car is equipped with a high voltage type electrical system.

Components in the high voltage system work with dangerous voltages.

These components are connected with orange wires.

Removal

Set the ignition key to position 0.

Remove the screws.

The part is not to be reused.

Accessory installation

Install component that comes with the accessory kit.

Install component that comes with the accessory kit.

Install the cable.

Route the cable harness to the existing cable harness.

Install component that comes with the accessory kit.

Install the screw.

Use: 1161721, Isopropanol

Wipe dry.

Use: 1161721, Cleaning agent

Wipe dry.

When installing Velcro tape the surface must maintain a temperature of at least +20 ° C (68°F).

Remove the protective film.

Locate the pre-routed connectors.

Connect the connectors.

When installing Velcro tape the surface must maintain a temperature of at least +20 ° C (68°F).

Clamp the cables and connectors to the existing cables to prevent noise.

Remove the clip.

Download software (application) for the accessory's function according to the service information in VIDA. See VIDA or the accessories catalogue for software part number.

Check

1. Left indicator lamp

2. Fog tail lamps.

3. Ground connection

4. Right indicator lamp

5. Right position lamp

6. Brake light

7. Left position lamp

8. Back-up lamp

9. Battery voltage, constant

10. Battery voltage, ignition on

11. Ground connection

12. Not connected

13. Ground connection

Reinstall the removed parts in reverse order.