Information

• Read through all of the instructions before starting installation.

• Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

• Ensure that all tools stated in the instructions are available before starting installation.

• Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

• In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

Color symbols

1. Used for focused component, the component with which you will do something.

2. Used as extra colors when you need to show or differentiate additional parts.

3. Used for attachments that are to be removed/installed. May be screws, clips, connectors, etc.

4. Used when the component is not fully removed from the vehicle but only hung to the side.

5. Used for standard tools and special tools.

6. Used as background color for vehicle components.

Preparation

Set the ignition key to position 0.

Removal

Remove the screws.

Remove the clips.

Applies to the left-hand side:

Turn the wheel inwards.

Remove the screws.

Applies to the right-hand side

Remove the screws.

Remove the nuts.

Remove the clip.

Remove the screws.

Remove the nuts.

Remove the hose.

Disconnect the connector.

Release the connector's catch.

Release the connector's secondary lock.

Disconnect the connector.

Accessory installation

Locate the existing connector in the vehicle's cable harness.

Install component that comes with the accessory kit.

Install the screw.

Install the nuts

Tightening torque: M6 , 10 Nm

Connect the connector.

Install the clip(s).

Removal

Remove the clips.

Remove the screws.

Remove the panel.

Remove the clips.

Remove the part carefully

Remove the screws.

Loosen the screws.

Accessory installation

Install component that comes with the accessory kit.

Route the cable harness to the existing cable harness.

Locate and disconnect the 2-pin connector that is taped to the car's cable harness.

Tighten the screw.

Tightening torque: M6 , 10 Nm

Install the screws.

Tightening torque: M6 , 10 Nm

Connect the cable harness.

Secure the connectors.

Installation

Reinstall the removed parts in reverse order.

Download software (application) for the accessory's function according to the service information in VIDA. See VIDA or the accessories catalogue for software part number.