2006 L.H.D

Installation Instruction

Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
V50 2006

Instruction NoVersionPart. No.Click to download PDF-version of this Installation Instruction
86858251.0
Fog lamps




Equipment
A0000162

J3501649





 
  

INTRODUCTION

  • Read through all of the instructions before starting installation.

  • Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

  • Ensure that all tools stated in the instructions are available before starting installation.

  • Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

  • In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

 

Installing fog lamps

1
J8601113
 

Installing fog lamps

  • Turn the ignition key to position 0

  • Detach the panel at the bottom edge of the bumper cover on the right-hand side. First press down the two upper catches for the panel from the outside. Use a weatherstrip tool

  • Carefully pry off the panel until the last catches release. Remove the panel. Do not damage the paintwork

  • Place the panel to one side. There is a new panel in the kit.

2A
J3501650
2B
J3501652
 

Illustration A

  • Disconnect the pre-routed connector for the fog lamp inside the removed panel

  • Connect the connector to the fog lamp. Insert the fog lamp in position. Ensure that the two pins are inserted into the corresponding cut outs in the bumper cover.

Illustration B

  • Install the two screws (from the kit). Tighten the fog lamp securely

  • Repeat for the fog lamp on the other side.

 

Installing the keypad

3
J8504684
 

Installing the keypad

  • Remove the keypad for the lighting. Carefully pry off the keypad from the dashboard. Use a weatherstrip tool. The keypad is secured by two catches on either side. Do not damage the dashboard.

4
J3904619
 

  • Disconnect the connector from the existing keypad. Remove the keypad. The keypad will not be used again

  • Connect the connector to the new keypad (from the kit)

  • Press the keypad into the dashboard.

 

Finishing work

5
J3501653
 

Finishing work

  • Set the height of the fog lamps using the adjustment screw.

6
J8601114
 

  • Install the new panels (from the kit) around the fog lamps in the bumper cover. Ensure that all the catches have engaged.