Information

• Read through all of the instructions before starting installation.

• Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

• Ensure that all tools stated in the instructions are available before starting installation.

• Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

• In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

Color symbols

1. Used for focused component, the component with which you will do something.

2. Used as extra colors when you need to show or differentiate additional parts.

3. Used for attachments that are to be removed/installed. May be screws, clips, connectors, etc.

4. Used when the component is not fully removed from the vehicle but only hung to the side.

5. Used for standard tools and special tools.

6. Used as background color for vehicle components.

Removal

Clean the Bumper Cover surface.

Use the template in the installation instructions.

Cut following the dotted lines.

Remove the screws.

Remove the nuts.

Fold the wing liner aside.

Accessory installation

Removal

Remove the panel.

Remove the screws.

Remove the clips.

Remove the panel.

Accessory installation

Install the screw.

Tightening torque: M6 , 10 Nm

Pull the wiring through.

Install a clips onto the upper edge of the subframe.

Removal

Place a container under the car.

Drain the coolant.

Tighten the nipple after draining the coolant.

Accessory installation

Install a clips onto the upper edge of the subframe.

Remove the hose.

Install the hose.

Install the hose.

Install the screw.

Tighten the hose clamps.

Lubricate the O-ring.

Use: 1161761, Grease

Install component that comes with the accessory kit.

Connect the cable.

Install the clip(s).

Install the clip(s).

Vehicles with passenger compartment connector

Connect the prerouted cables.

1. Cable from Engine block heater

2. Passenger Compartment Connector Cable

3. Cable from front socket

Install the clips as illustrated.

Vehicles without passenger compartment connector

Connect the prerouted cables.

Install the clip(s).

Install the cable.

Installation

Clamp the cables and connectors to the existing cables to prevent noise.

Reinstall the removed parts in reverse order.

Fill with coolant and run the engine to operating temperature.

Vent the cooling system and check for leakage.

Post-fill the cooling system if necessary.