• Set the ignition key to position 0.

  
  

  Note! Wait at least one minute before unplugging the connectors or removing other electrical equipment.

  
  

• Remove the tailgate's sill panel by pulling it up until the four clips on the upper side and the eight catches at the lower edge release.

• Lift out the spare wheel, jack and other parts from the storage compartment in the cargo floor support.

• Pull off the seat cushion, first at the rear edge where it is secured by one holder. Then at the front edge where it is secured by two holders.

• Remove the seat cushion.

• Fold the central arm rest forward.

• Remove the central arm rest by grasping each end and pulling upwards until it releases at the rear edge from the backrest's lugs (1).

• Then pull forwards until the holders (2) on the sides of the backrest have slid out of the corresponding cut-out (3) in the central arm rest.

• Fold the backrest forward.

• Remove the panel for the backrest's right-hand mounting.

• Fold the backrest away from the right-hand mounting.

• Pull it out from the mounting at the arm rest and remove it.

• Pull off the rubber molding at the rear edge of the right-hand door opening.

• Remove the right-hand B pillar panel by prying it off at the sides at the lower edge using a weatherstrip tool. It is secured by three clips on the inside.

• Remove the screw from the right-hand panel in the rear seat.

• Carefully pull the panel from the body side and unhook it from the sill panel at the front edge. It is secured by eleven clips on the inside.

• Remove the clips at the rear edge of the right-hand rear side panel.

• Carefully pull the side panel off, starting at the front edge/upper edge and then straight back until all clips at the top edge have released.

• Fold the panel inwards. Release it from the anchorage eyelets and lift it out of the load floor support.

• Use: Isopropanol, 1161721. Wipe dry.

• When installing Velcro fasteners/tape, the underlying surface must be kept at a temperature of at least +20° C (68°F).

• Find the grey 2-pin and green 5-pin connectors under the corner of the cargo compartment floor support. Lift up the cargo compartment floor support enough to improve accessibility.

• Use Isopropanol, 1161721. Wipe dry.

  
  

  Note! Do not position the lower edge of the control module below the dashed line, as the body plate is folded here.

  
  

• Plug in the connectors.

Applies to cars from chassis number 39000-

• Pull up the catch on the cover on the fuse box in the engine compartment. Pull up the cover and remove it.

• Install a 40A fuse in position 14.

  
  

  Note! The fuse included in the TRM kit must NOT be used.

  
  

• Reinstall the cover.

• Reinstall the detached components in reverse order.

• Download the software (application) for the accessory's function following the service information in VIDA.

  See VIDA or the accessories catalogue for software part number.