Information

• Read through all of the instructions before starting installation.

• Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

• Ensure that all tools stated in the instructions are available before starting installation.

• Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

• In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

Conditions

There may be parts in the accessories kit that are not needed for this installation.

Color symbols

1. Used for focused component, the component with which you will do something.

2. Used as extra colors when you need to show or differentiate additional parts.

3. Used for attachments that are to be removed/installed. May be screws, clips, connectors, etc.

4. Used when the component is not fully removed from the vehicle but only hung to the side.

5. Used for standard tools and special tools.

6. Used as background color for vehicle components.

Removal

1. Set the ignition key to position 0.

2. Remove the battery's negative cable.

Tightening torque: Wheel to wheel hub
Stage 1: 20 Nm
Stage 2: 140 Nm

Remove the screws.

Remove the screws.

Remove the nuts.

Remove the tape.

Accessory installation

Use special tool: T9512782, Rivet nut tool

Removal

Release the lock.

Remove the clips.

Remove the screws.

Accessory installation

Clean the Bumper Cover surface.

Use the template in the installation instructions.

Cut following the dotted lines.

Use tape

Deburr edges

Pull the wiring through.

Install the screw.

Install the clip(s).

Install the clip(s).

Vehicles with Alarm siren

Removal

Disconnect the connector.

Remove the screws.

All vehicles

Accessory installation

Install the screws.

Install the clip(s).

Install the catch.

Install the cables.

Vehicles with Alarm siren

Install the screw.

Install the screws.

Connect the connector.

Vehicles without Alarm siren

Install the screw.

Install the screws.

Install the nuts

All vehicles

Install the clip(s).

Install the clip(s).

Removal

Fold the insulation aside.

Pull the wiring through.

Pull the wiring through.

Refit the insulation.

Remove the cable harness clips.

Remove the cable harness clips.

Disconnect the connector.

Loosen the hose clamp.

Remove the screw.

Accessory installation

Installation

Reinstall the screw.

Accessory installation

Install the clip(s).

Install the screw.

Tightening torque: M6 , 10 Nm

Removal

Accessory installation

Use: Expander pliers

Pull the wiring through.

Use: , Electrical tape

Wrap tape around the cable to increase the diameter.

Increase the diameter to 6.5 mm.

Remove the nut.

Tightening torque: M6 , 10 Nm

Install the nut.

Clean the surface.

Use: 1161721, Isopropanol

Use: , Electrical tape

Installation

Accessory installation

Reinstall the removed parts in reverse order.