Information

• Read through all of the instructions before starting installation.

• Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

• Ensure that all tools stated in the instructions are available before starting installation.

• Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

• In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

There may be parts in the accessories kit that are not needed for this installation.

Color symbols

1. Used for focused component, the component with which you will do something.

2. Used as extra colors when you need to show or differentiate additional parts.

3. Used for attachments that are to be removed/installed. May be screws, clips, connectors, etc.

4. Used when the component is not fully removed from the vehicle but only hung to the side.

5. Used for standard tools and special tools.

6. Used as background color for vehicle components.

Removal

Set the ignition key to position 0.

Remove the panel.

Disconnect the connector.

Fold the carpet aside.

Locate the rubber grommet under the insulating mat.

Make a cut in the insulation.

Fold the insulation aside.

Raise the car.

1. Remove the clips.

2. Remove the screws.

The part is not to be reused.

Loosen the clip.

Disconnect the connector.

Accessory installation

Use: 1161427, Low temperature grease

Install the catch.

Use: 1161427, Low temperature grease

Install the clip(s).

Tighten the cable ties.

Make a cut in the insulation.

Fold the insulation aside.

Insert the cable in to the passenger compartment, adjust the cable length out into the engine compartment and secure the rubber grommet.

Use: 1161427, Low temperature grease

Install the catch.

Fold the insulation aside.

Vehicles with Child seat mounting eyelets

Remove the screw.

Install the screw.

All vehicles

Install the screw.

Refit the insulation.

Make a cut in the insulation.

Fold the floor carpet back.

Make a cut in the mat.

Fold the carpet back towards the bracket.

Install the screws.

Reinstall the removed parts in reverse order.