Steps 1-10 apply to S60/V70/V70XC

Steps 1-10 apply to S60/V70/V70XC

• Turn the ignition switch to position 0.

• Remove the clips (1) by pressing in the centre pins and then removing them.

• Remove the cover panel (2) to the door handle. Use a weatherstrip tool. Start at the top or bottom edge.

• Remove the two screws (3) under the cover panel.

• Remove the cover (4) for the door mirror by carefully prizing it away all around using a weatherstrip tool.

• Detach the door panel. First slide the panel upwards and unhook the top edge.

• Detach the cable to the door opener.

• Detach the connectors to the door module and to the treble loudspeaker.

• Place the door panel to one side.

• Unplug the connectors to the door mirror.

• Carefully prize up the catch on the sixteen-pin green connector to the door mirror.

• Take the pink (P) cable and connect the end of the cable with the thin cable terminal in position 14 in the connector.

• Snap in the catch and plug in the connector.

• Route the cable to the thirty-pin green connector as illustrated.

• Carefully prize up the catch on the thirty-pin green connector.

• Take the other end of the cable routed previously and connect it in position 29 in the connector.

• Snap in the catch.

• Take three tie straps from the kit and clamp in the routed cable at the existing cable harness.

• Plug in the connectors to the door module and the treble loudspeaker.

• Connect the cable to the door opener.

• Reinstall the door panel with clips, screws and cover panel.

• Reinstall the cover to the door mirror.

Steps 11-22 apply to the S80

Steps 11-22 apply to the S80

• Turn the ignition switch to position 0.

• Carefully prize up the cover in the door handle using a weatherstrip tool and remove the screw underneath.

• Carefully prize away the door opener surround all around using a weatherstrip tool.

• Remove the clips (1) by pressing in the centre pins and then removing them.

• Remove the cover panel (2) to the door handle. Use a weatherstrip tool. Start at the top or bottom edge.

• Remove the two screws (3) under the cover panel.

• Remove the cover (4) for the door mirror by carefully prizing it away all around using a weatherstrip tool.

• Detach the door panel. First slide the panel upwards and unhook the top edge.

• Detach the connectors to the door module and to the treble loudspeaker.

• Place the door panel to one side.

• Unplug the connectors to the door mirror.

• Carefully prize up the catch on the sixteen-pin green connector to the door mirror.

• Take the pink (P) cable and connect the end of the cable with the thin cable terminal in position 14 in the connector.

• Route the cable to the thirty-pin green connector as illustrated.

• Carefully prize up the catch on the thirty-pin green connector.

• Take the other end of the cable routed previously and connect it in position 29 in the connector.

• Snap in the catch.

• Take three tie straps from the kit and clamp in the routed cable at the existing cable harness.

• Plug in the connectors to the door module and the treble loudspeaker.

• Reinstall the door panel with clips, screws, cover panels and surround.

• Reinstall the cover to the door mirror.