2006 2.5T AWD AUTOMATIC L.H.D

Monteringsveiledning

Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
V70 2006
V70 (00-08) 2006

Instruction NoVersionPart. No.Click to download PDF-version of this Installation Instruction
86855081.0
Sunglasses holder




D8901311




Equipment
A0000159
A0000160

A8901363





 
  

INTRODUCTION

  • Read through all of the instructions before starting installation.

  • Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

  • Ensure that all tools stated in the instructions are available before starting installation.

  • Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

  • In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

1A
R8902639
1B
R8902640
1C
A8901364
1D
A8901366
1E
A8901368
 

Thoroughly clean the surface where the sunglasses holder is to be positioned. Use denatured alcohol.

Illustration A applies to the XC90

Illustration B applies to the XC90

  • The most suitable places for the sunglasses holder, in the XC90, is either on the roof panel between the sun visors (see illustration A), or on the dashboard (see illustration B).

Illustration C applies to the 850, 900, S40, V40, C70 coupé, S70, V70, S90 and V90 without a sunroof or with a power sunroof

  • The most suitable location for the sunglasses holder for these models is at the rear edge of the panel (1).

Illustration D applies to the S70 and V70 with manual sun roofs, the C70-cabriolet, the S60 and S80

  • The most suitable location for the sunglasses holder in these models is in the centre of the panel recess as illustrated.

Illustration E applies to the 400

  • The most suitable place for the sunglasses holder in the 400 is on the dashboard as illustrated.

2
A0000160
 

  • Remove the backing from the sunglasses holder

  • Install the sunglasses holder. Press the tape hard against the surface underneath. Hold for a moment.


    Note!

    After mounting, the tape must be allowed to cure for 24 hours at a minimum of +15°C (60°F) before the sunglasses holder can be used.


3
 

  • Place the sunglasses in the holder. Secure the glasses using the strap as illustrated.