Mudguard front - V70 2006 2.5T AWD Automatic

INTRODUCTION

Read through all of the instructions before starting installation.
Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.
Ensure that all tools stated in the instructions are available before starting installation.
Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.
In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

M8600823

Remove the rear wheels
Carefully drill out the four rivets holding the rear edge of the bumper liner at the front edge of the front bumper. Use a Ø 6 mm (1/4 “) drill bit.

Note!
Do not damage any of the plastic components.

M8600824

Clean the marked surface using a mixture of 30 % windscreen washer fluid and 70 % water. Wipe dry.

M8600825

Remove the backing from the masking tape
Secure the masking tape at the front edge on the front bumper cover. Position the tape just in front of curve of the front bumper cover as illustrated
Secure the masking tape along the length of the front edge first. Then press backwards firmly. Puncture any air bubbles using a needle
Press the masking tape into place firmly.

M8902354

Install the mudguard. Rivet the mudguard into place in the bumper liner and the front edge bumper cover
Reinstall the front wheels. Tighten the wheels. Tighten to 110 Nm (96 lbf. ft).

Monteringsveiledning