Information

• Read through all of the instructions before starting installation.

• Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

• Ensure that all tools stated in the instructions are available before starting installation.

• Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

• In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

Color symbols

1. Used for focused component, the component with which you will do something.

2. Used as extra colors when you need to show or differentiate additional parts.

3. Used for attachments that are to be removed/installed. May be screws, clips, connectors, etc.

4. Used when the component is not fully removed from the vehicle but only hung to the side.

5. Used for standard tools and special tools.

6. Used as background color for vehicle components.

Preparation

Set the ignition key to position 0.

Removal

Remove the panel.

Remove the screws.

Remove the panel.

Remove the part carefully

Disconnect the connector.

Remove the panel.

Remove the panel.

Remove the panel.

Accessory installation

Install component that comes with the accessory kit.

Install component that comes with the accessory kit.

Install the screws.

Note the position.

Install the screw.

Install the nuts

Tightening torque: M6 , 10 Nm

Locate the pre-routed connectors.

Connect the connectors.

Fasten the wiring harness using the existing clips.

Installation

Reinstall the removed parts in reverse order.

Carry out a download, or a re-load, of accessory function software by following VIDA service information.