2018 R.H.D

Installation Instruction

Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
S60 2018
S60 (11-18) 2018

Instruction NoVersionPart. No.Click to download PDF-version of this Installation Instruction
307580771.030756499
Mesh pocket, cargo compartment, side panel




IMG-339771




Equipment
A0000162
IMG-239660
IMG-239681
IMG-339772


 
  

INTRODUCTION

  • Read through all of the instructions before starting installation.

  • Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

  • Ensure that all tools stated in the instructions are available before starting installation.

  • Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

  • In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

 
1
IMG-339778
 

    Mesh pocket right side

  • Apply the strips of tape as illustrated.

  • Make marks for drilling holes for the mesh pocket mountings.

  • Drill out the hole.

2
IMG-339785
 

  • Insert the pocket's rear mounting in the hole in the panel and fold down.

3
IMG-339776
 

  • Insert the mesh pocket's front mounting towards the panel and lower end towards the floor.

4
IMG-339773
 

  • Move the front mounting to one side and drill the hole.

5
IMG-339774
 

  • Insert the front mounting in the panel and fold down the mesh pocket.

6
IMG-339775
 

  • Drill out the holes in the panel through the two clips.

7
IMG-339842
 

  • Tighten the mesh pocket's lower end

8
IMG-339781
 

    Mesh pocket left side

  • Apply the strips of tape as illustrated.

  • Make marks for drilling holes for the mesh pocket mountings.

  • Drill out the hole.

9
IMG-339784
 

  • Insert the rear mounting in the panel and fold down the mesh pocket.

10
IMG-339783
 

  • Insert the mesh pocket's front mounting towards the panel and lower end towards the floor.

  • Mark the hole in the panel level with the middle of the radius of the bent wire frame.

11
IMG-339779
 

  • Move the front mounting to one side and drill the hole.

12
IMG-339782
 

  • Insert the front mounting in the panel and fold down the mesh pocket.

13
IMG-339805
 

Applies to vehicles with control module for electric handbrake.

  • Measure and place the clips in the wire frame. Measure between the rear edge panel and centre.

14
IMG-339804
 

15
IMG-339802
 

  • Remove the clips.

16
IMG-339806
 

  • Lift up the panel and check that the clips are positioned so that the control module and cable harness are not drilled. Move the clips if necessary.

  • Reinstall the panel.

17
IMG-339802
 

18
IMG-339803
 

19
IMG-339775
 

Applies to all models

  • Drill out the holes in the panel through the two clips.

20
IMG-339842
 

  • Tighten the mesh pocket's lower end.

© Volvo Car CorporationMesh pocket, cargo compartment, side panel- 30758077 - V1.0
volvocars.com
Lifestyle Collection
日本語
Find a Dealer
Japan

Cookies Legal Disclaimer Privacy Policy Copyright

Copyright © 2024 Volvo Cars. All rights reserved.