Information

• Read through all of the instructions before starting installation.

• Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

• Ensure that all tools stated in the instructions are available before starting installation.

• Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

• In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

Further information

There may be parts in the accessories kit that are not needed for this installation.

Color symbols

1. Used for focused component, the component with which you will do something.

2. Used as extra colors when you need to show or differentiate additional parts.

3. Used for attachments that are to be removed/installed. May be screws, clips, connectors, etc.

4. Used when the component is not fully removed from the vehicle but only hung to the side.

5. Used for standard tools and special tools.

6. Used as background color for vehicle components.

7. Used for accessory components.

Removal

Open the hood.

Remove the marked detail/details.

Use: Pliers 31423632

Remove the screws.

Remove the marked part.

Remove the screws.

Remove the marked part.

Remove the clips.

Remove the nuts.

Remove the screws.

Remove the clip.

Remove the marked part.

Accessory installation

Secure the template with tape.

Cut out following the template.

Make a mark by cutting a thin cut.

Remove template.

1. Use a drill with the stated size

2. Use: Air-powered air saw
   

Install component that comes with the accessory kit.

Check that the flange of the part is in full contact with bumper cover.

Adjust the hole with a file or knife as necessary.

Install component that comes with the accessory kit.

Install components that come with the accessory kit.

Install component that comes with the accessory kit.

This is used as a counterhold.

Tighten the nut.

Use hands only.

Ground connection

Release the catches.

Fold marked part aside.

Remove the nut.

The item is to be reused.

Connect the prerouted cable.

Reinstall the removed part.

Install the nut.

Tightening torque: M6 , 10 Nm

Cable from front socket

Lubricate the O-ring.

1. Cable from front socket

2. Engine heater cable

Connect the cable.

Install the catch.

Place the cable tie as illustrated.

Position/route the cable as illustrated.

Position/route the cable as illustrated.

Position/route the cable as illustrated.

Attach the clip.

Place the cable tie as illustrated.

Position/route the cable as illustrated.

Tighten the cable tie.

Place the cable tie as illustrated.

Position/route the cable as illustrated.

Tighten the cable tie.

Place the cable tie as illustrated.

Position/route the cable as illustrated.

Tighten the cable tie.

Place the cable tie as illustrated.

Position/route the cable as illustrated.

Tighten the cable tie.

1. Steering gear

2. Engine heater cable

Position/route the cable as illustrated.

Install the cable.

Use a cable tie

Secure the cable with clips in the subframe flange.

Remove the screws.

Clean the surface.

Install components that come with the accessory kit.

Tighten the screw.

Remove the protective film.

Install component that comes with the accessory kit.

Press the marked component.

Install components that come with the accessory kit.

Tighten the screw.

Lubricate the O-ring.

Connect the prerouted cable.

Install the catch.

Fasten the cable tie without tightening.

Adjust the cable position so that it can follow the motions of the engine.

Tighten the cable tie.

Installation

Reinstall the removed parts in reverse order.

Tightening torque: Aluminum wheel rim to wheel hub
Stage 1: 4 Nm
Stage 2: 50 Nm
Stage 3: 140 Nm