Information

• Read through all of the instructions before starting installation.

• Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

• Ensure that all tools stated in the instructions are available before starting installation.

• Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

• In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

Conditions

When installing, the car must retain a temperature of 20 degrees C.

After installation, the car must not be washed for 48 hours

Color symbols

1. Used for focused component, the component with which you will do something.

2. Used as extra colors when you need to show or differentiate additional parts.

3. Used for attachments that are to be removed/installed. May be screws, clips, connectors, etc.

4. Used when the component is not fully removed from the vehicle but only hung to the side.

5. Used for standard tools and special tools.

6. Used as background color for vehicle components.

7. Used for accessory components.

Preparation

Open the tailgate.

Clean the surface.

Wipe off

Use: , Isopropanol

Allow to dry.

1. Use: Masking tape
   

2. Mark the centre.

Accessory installation

Mark the centre.

Fold the protective film forward

Place the component where indicated in the graphic.

Measure

Use: Vernier caliper

Allow the Bumper Protection to adhere to the Bumper Cover as indicated.

Use: , Masking tape

Remove the protective film.

Remove the tape.

Pull off the rest of the transparent foil and press by hand on the Bumper protection to make it cling to the Bumper Cover.

Thoroughly press, by hand, all over the Bumper Protection to make it cling properly.

Remove the tape.

Remove the protective film.