• Open boot lid.

• Lift up the cargo compartment divider.

• Remove the covers on each side of the divider.

• Unscrew the two nuts on each side of the divider four turns.

• Lower the divider slightly.

• Unscrew the third nut on each side of the divider four turns.

• Lower the divider completely.

• Detach the wire frame from the clip.

• Use a cable tie or the like to lock the divider's two arms on the right and left side.

• Remove the divider by taking hold of the arms and lifting upward.

Remove:

• the toolbox cover.

• the spare wheel, if in place.

• Take the tools out of the toolbox.

Remove:

• the clip.

• the screw.

• the toolbox.

• Remove the three screws and the load retaining eyelets from the floor.

• Remove the cover from the trunk lid stop. Use a weatherstrip tool to pry between the cover and the stop to release the catches.

• Remove the two light bulbs by pressing in the two catches at the top with a screwdriver.

For cars with emergency release handle in cargo compartment

• Remove the emergency opening handle by pressing out the pin at the eye and unhook the wire.

• Remove the two screws in the sill moulding.

• Remove the sill moulding by pulling it up until the clips release.

• Fold the sill moulding aside.

• Remove the cargo compartment carpeting.

• Remove the rubber stop on the roof's stop brace.

• Mark out the stop bracket for the roof in relation to the screw.

• Remove the screw and the roof's stop brace.

• Remove the load divider lock by using a weatherstrip tool to pry between the carpet and lock.

• If performing the operation on the left side, unplug the connector.

• Remove the screw and the lashing eye on the right side.

• Remove the stop brace cover.

• Mark out the stop braces for the roof in relation to the screws and nuts on the right side.

• Remove the screw, nut and the roof's stop braces.

• Loosen the four clips on the right side panel.

• Remove the side panel by unhooking it from the stop lug at the front edge and the pulling outward and upward so that it releases from the sealing strip.

• Remove the support.

  This will not be reused.

• Clean the surfaces. Use: Isopropanol.

• Install the tape.

• Install the console.

• Install the support.

Reinstall the detached components in reverse order.

Tightening torque for load securing eyelets: 24 Nm (17 lbf.ft.).