2016 L.H.D

Installation Instruction

Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
XC70 2016
XC70 (08-) 2016

Instruction NoVersionPart. No.Click to download PDF-version of this Installation Instruction
313164861.630756607, 31316446, 31330933, 31390471, 31369832, 31369831, 31369830, 31373333
Steering wheel




IMG-345467




Equipment
IMG-345497
IMG-239667
IMG-239664

IMG-344716


 
 

Information

1
 

  • Read through all of the instructions before starting installation.

  • Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

  • Ensure that all tools stated in the instructions are available before starting installation.

  • Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

  • In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

 

Conditions

2
IMG-331412
 

Warning!
The supplemental restraint system (SRS) is active for a certain length of time after the power supply has been disconnected. Wait for a minimum of 30 seconds before disconnecting or removing any SRS components.

3
IMG-331413
 
 

Removal

4
IMG-332180
 

Set the ignition key to position I.

Remove the battery's negative cable.

5
IMG-344717
 
6
IMG-344721
 
7
IMG-344722
 

Remove the panel.

8
IMG-344723
 

Remove the panel.

9
IMG-344724
 
10
IMG-337683
 
11
IMG-344725
 
12
IMG-344726
 
13
IMG-344727
 
14
IMG-344728
 
15
IMG-344763
 
16
 

Repeat the steps when removing on opposite side.

17
IMG-345493
 

Turn the steering wheel into neutral position.

18
IMG-344730
 

Disconnect the connectors.

19
IMG-344731
 

Warning!
Place the airbag module with the front side facing up in a safe storage area during work.

20
IMG-344732
 

Note!
This step requires considerable force.

21
IMG-344762
 

Note!
This step requires considerable force.

22
IMG-344733
 

Disconnect the connector.

23
IMG-344734
 

Note!
This step requires considerable force.

Repeat on the other side.

24
IMG-344121
 

Note!
The number of connectors, cables and cable ties can vary depending on the vehicle's equipment level.

Repeat on the other side.

25
IMG-344735
 

Note!
Do not loosen the bolt more than 4 turns.

26
IMG-344736
 
27
IMG-344737
 
28
IMG-344738
 

Remove the clip.

 

Installation

29
IMG-344739
 
30
IMG-344740
 

Caution!
Make sure that no part of the wiring harness is trapped.

31
IMG-344741
 

Note!
Only tighten the nut finger tight at this stage.

32
IMG-344742
 
33
IMG-344743
 


Tightening torque: M10 , 50 Nm

34
IMG-344744
 

Repeat on the other side.

35
IMG-344745
 
36
IMG-344746
 

Connect the connector.

Install the clips as illustrated.

37
IMG-344747
 
38
IMG-339675
 
39
IMG-344748
 

Connect the connectors.

40
IMG-344749
 
41
IMG-344758
 

Install the panel.

42
IMG-344751
 

Install the panel.

43
IMG-337646
 

Note!
Make sure that the ignition key is in the OFF position.

Reinstall the battery's negative cable.

44
IMG-336904
 

Warning!
When switching the ignition on for the first time after a battery disconnect and connect, make sure to stand outside the vehicle and only reach into the vehicle keeping clear of the air bag deployment areas.