Installation Instruction

Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
S80 2014
S80L 2014 L.H.D

Instruction NoVersionPart. No.Click to download PDF-version of this Installation Instruction
313595341.131339994
Parking assistance camera wide angle front




IMG-373506




 

Materials

Designation

Part number

Low temperature grease

1161427


Equipment
IMG-242205
IMG-345497
IMG-300203
IMG-327738
IMG-239667
IMG-244945
IMG-240693

IMG-353085


 
 

Information

1
 

  • Read through all of the instructions before starting installation.

  • Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

  • Ensure that all tools stated in the instructions are available before starting installation.

  • Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

  • In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

 

Conditions

2
IMG-332179
 

Set the ignition key to position 0.

Remove the battery's negative cable.

 

Color symbols

3
IMG-363036
 

Note!
This colour chart displays (in colour print and electronic version) the importance of the different colours used in the images of the method steps.

  1. Used for focused component, the component with which you will do something.

  2. Used as extra colors when you need to show or differentiate additional parts.

  3. Used for attachments that are to be removed/installed. May be screws, clips, connectors, etc.

  4. Used when the component is not fully removed from the vehicle but only hung to the side.

  5. Used for standard tools and special tools.

  6. Used as background color for vehicle components.

 

Removal

4
IMG-354313
 

Remove the panel.

5
IMG-354315
 

Remove the panel.

6
IMG-354318
 

Remove the weatherstrip.

7
IMG-354319
 

Remove the panel.

8
IMG-344930
 
9
IMG-354320
 
10
IMG-349804
 

Remove the panel.

11
IMG-349806
 

Remove the screws.

12
IMG-345282
 

Remove the screws.

 

Cars with manual transmissions

13
IMG-345747
 

Release the lock ring which is located inside the gear lever boot.

14
IMG-347222
 
 

Cars with automatic transmissions

15
IMG-345283
 
16
IMG-345284
 

Release the shift-lock function.

Move the gear lever to D.

 

All vehicles

17
IMG-341878
 

Remove the panel.

18
IMG-346036
 

Remove the panel.

19
IMG-340599
 
  1. Fold the carpet to the side.

  2. Unhook the clip(s).

  3. Disconnect the connector.

20
IMG-350000
 
21
IMG-349811
 

Remove the screws.

22
IMG-347139
 

Remove the panel.

 

Vehicles with the 4C system.

23
IMG-345317
 

Disconnect the connector.

 

All vehicles

24
IMG-349826
 

Caution!
Be careful not to damage the catches.

Remove the panel.

25
IMG-340605
 

Remove the screws.

26
IMG-345296
 

Detach the panel.

27
IMG-345763
 
 

Accessory installation

28
IMG-345764
 
 

Removal

29
IMG-349942
 

Remove the screws.

30
IMG-349946
 
31
IMG-353492
 

Caution!
The number of connectors can vary depending on the vehicle's equipment level.

Disconnect the connectors.

32
IMG-354616
 
33
IMG-354618
 
34
IMG-354649
 

Remove the panel.

35
IMG-370585
 

Remove the screws.

36
IMG-370584
 
37
IMG-349901
 

Caution!
The number of connectors can vary depending on the vehicle's equipment level.

Disconnect the connectors.

38
IMG-349903
 
39
IMG-353512
 
40
IMG-353511
 

Remove the screws.

41
IMG-349993
 

Remove the panel.

42
IMG-350006
 

Remove the panel.

43
IMG-352301
 

Remove the screws.

On both sides.

44
IMG-352271
 

Remove the panel.

45
IMG-350026
 

Remove the screws.

46
IMG-349999
 

Detach the panel.

47
IMG-349992
 

Disconnect the connector.

 

Accessory installation

48
IMG-350072
 
49
IMG-355161
 

Caution!
Make sure that no part of the wiring harness is trapped.

Facilitate cable routing by temporarily raising the floor bracket using a socket or similar.

Pull the wiring through.

50
IMG-355174
 

Connect the connectors.

51
IMG-355175
 

Tear off the excess foam tape.

52
IMG-355200
 

Route the cable harness to the existing cable harness.

53
IMG-345857
 

Route the cable harness to the existing cable harness.

Pull the wiring through.

Install the cable.

54
IMG-355206
 
55
IMG-345863
 

Connect the connectors.

56
IMG-349904
 
 

Removal

57
IMG-352186
 
58
IMG-352187
 

Fold the carpet to the side.

59
IMG-353339
 

Locate the rubber grommet under the insulation and press it out.

 

Accessory installation

60
IMG-345859
 

Note!
Do not yet tighten the clamps.

Route the cable harness to the existing cable harness.

61
IMG-345860
 
 

Installation

62
IMG-353491
 

Connect the connectors.

63
IMG-349948
 
64
IMG-349942
 

Install the screws.

 

Removal

65
IMG-345877
 

Remove the screws.

Remove the clips.

66
IMG-345878
 
67
IMG-345879
 

Note!
On some markets the rubber grommet may be covered by the heat shield.

 

Accessory installation

68
IMG-345880
 

Pull the wiring through.

69
IMG-345881
 
70
IMG-353681
 

Caution!
Take extra care when handling the component.

Use: 1161427, Low temperature grease

71
IMG-345883
 
 

Removal

72
IMG-373507
 
73
IMG-353377
 

Release the catches.

74
IMG-373508
 
75
IMG-353381
 

Disconnect the connector.

76
IMG-373509
 
77
IMG-273585
 
78
IMG-340533
 

Remove the nuts.

 

Accessory installation

79
IMG-340606
 
80
IMG-345884
 

Pull the wiring through.

81
IMG-345885
 

Caution!
Make sure to locate the wiring in such a way that any damage caused by heat or excessive wear is avoided.


Note!
Do not yet tighten the clamps.

Route the cable harness to the existing cable harness.

82
IMG-345886
 

Note!
Do not yet tighten the clamps.

83
IMG-345887
 

Note!
Do not yet tighten the clamps.

Route the cable harness to the existing cable harness.

84
IMG-353446
 

Note!
Do not yet tighten the clamps.

85
IMG-353447
 

Note!
Do not yet tighten the clamps.

86
IMG-345889
 
87
IMG-340544
 

Caution!
Make sure to locate the wiring in such a way that any damage caused by heat or excessive wear is avoided.

Insert the cable in to the passenger compartment, adjust the cable length out into the engine compartment and secure the rubber grommet.

88
IMG-354476
 

Caution!
Tighten clamps properly.

 

Removal

89
IMG-373510
 

Note!
Orientation view

90
IMG-373511
 
 

Accessory installation

91
IMG-373512
 
92
IMG-347781
 
93
IMG-347786
 
94
IMG-373513
 
95
IMG-373514
 
96
IMG-373515
 

Connect the connector.

97
 

Reinstall the removed parts in reverse order.

98
IMG-336901
 

Reinstall the battery's negative cable.

99
IMG-242268
 

Download software (application) for the accessory's function according to the service information in VIDA. See VIDA or the accessories catalogue for software part number.

Order and download software according to: 31288598