Information

• Read through all of the instructions before starting installation.

• Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

• Ensure that all tools stated in the instructions are available before starting installation.

• Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

• In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

Conditions

When installing, the car must retain a temperature of 20 degrees C.

After installation, the car must not be driven for 2 hours

After installation, the car must not be washed for 48 hours

Clean the surface.

Allow to dry.

Use suitable tape to indicate the center.

Use suitable tape to indicate the center.

Cut off a piece of the transparent foil, as indicated.

Cut off a piece of the transparent foil, as indicated.

Center the Bumper Cover, using the tape marks and the values in the graphic.

Use appropriate tape to mark the position.

Clean the Bumper Cover surface.

Allow to dry.

Use: 1161721, Isopropanol

Cut in the lower transparent foil in the middle.

Pull off the top protection foil, if applicable.

Adjust the position of the Bumper Protection using the tape marks.

Partly fold back the transparent foil to expose the sticky surface.

Allow the Bumper Protection to adhere to the Bumper Cover as indicated.

Pull off the rest of the transparent foil and press by hand on the Bumper protection to make it cling to the Bumper Cover.

Pull off the rest of the transparent foil and press by hand on the Bumper protection to make it cling to the Bumper Cover.

Thoroughly press, by hand, all over the Bumper Protection to make it cling properly.

Use suitable tool to squeeze out any trapped air bubbles.