Installation Instruction

Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
S40 2011
S40 (04-) 2011

Instruction NoVersionPart. No.Click to download PDF-version of this Installation Instruction
312616881.331261689
Mudflaps, front, unpainted sill / Mudflaps, rear




J8903264




 
Equipment
A0000162
IMG-239660
IMG-239940

J8903486

J8903487

IMG-213320


 
  

INTRODUCTION

  • Read through all of the instructions before starting installation.

  • Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

  • Ensure that all tools stated in the instructions are available before starting installation.

  • Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

  • In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

 

Installing front mudguard

1
J8903491
 

Installing front mudguard

  • Turn the wheels to the left

  • Clean the area at the rear edge of the wing liner where the mudguard will be positioned

  • Remove the three screws holding the wing liner to the body. Place the screws to one side. New screws are supplied in the kit.

2
J8903492
 

  • Clean the marked surface at the rear edge of the front wing. Use a mixture of 30% windscreen washer fluid and 70% water. Wipe dry.

3
J8601115
 

  • Remove the backing from the masking tape

  • Secure the masking tape at the front edge on the front wing. Position the tape just inside the curve of the front wing as illustrated

  • Secure along the entire front edge first. Then securely press backwards. Puncture any air bubbles using a needle

  • Press the masking tape into place firmly.

4
J8903493
 

  • Clean around the screw holes in the rear edge of the wing liner

  • Take the mudguard, new screws and rivet from the kit. Tighten the mudguard to the wing liner and body

  • Drill a hole through the upper hole in the mudguard and into the wing liner. Use a 5 mm (3/16”) diameter drill bit

  • Remove any swarf

  • Rivet the upper mounting of the mudguard to the wing liner

  • Repeat the above points on the other side.

 

Installing rear mudguard

5
J8903278
 

Installing rear mudguard

  • Clean the area at the rear edge of the wing liner where the mudguard will be positioned

  • Remove the four screws holding the wing liner to the bumper cover. Place the screws to one side. New screws are supplied in the kit.

6
J8903262
 

  • Clean around the screw holes in the rear edge of the wing liner

  • Take the mudguard and the new screws from the kit. Tighten the mudguard to the wing liner and the bumper cover

  • Repeat the above points on the other side.