Information

• Read through all of the instructions before starting installation.

• Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

• Ensure that all tools stated in the instructions are available before starting installation.

• Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

• In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

Color symbols

1. Used for focused component, the component with which you will do something.

2. Used as extra colors when you need to show or differentiate additional parts.

3. Used for attachments that are to be removed/installed. May be screws, clips, connectors, etc.

4. Used when the component is not fully removed from the vehicle but only hung to the side.

5. Used for standard tools and special tools.

6. Used as background color for vehicle components.

Removal

Open the hood.

Fold marked part aside.

Remove the marked part.

Remove the marked part.

Remove the clips.

Remove the screws.

Remove the marked part.

Remove the clips.

Place a container under the car.

Drain the coolant.

Remove the marked part.

Use: Pliers

Remove the screws.

Remove the marked part.

Remove the screws.

Remove the clips.

Remove the nuts.

Remove the screw.

Remove the screws.

Remove the marked part.

Remove the screw.

Remove the clips.

Remove the marked part.

Accessory installation

Locate relevant marking.

Use: Air-powered air saw

Adjust the hole with a file or knife as necessary.

Install component that comes with the accessory kit.

Pull the wiring through.

1. Install component that comes with the accessory kit.

2. Use hands only.

Tighten the nut.

Install the clip(s).

Tighten the cable tie.

Release the catches.

Fold marked part aside.

Remove the nut.

The part is to be reused.

Connect the prerouted cable.

Install the nut.

Tightening torque: M6 , 10 Nm

Press until a click is heard.

Lubricate the O-ring.

Install component that comes with the accessory kit.

Connect the cable.

Install the catch.

Install the clip(s).

Tighten the cable tie.

Install the clip(s).

Tighten the cable tie.

Install component that comes with the accessory kit.

Tighten the screw.

Tightening torque: M6 , 10 Nm

Remove the screw.

The part is to be reused.

1. Fold marked part aside.

2. Install component that comes with the accessory kit.

3. Tighten the screw.

Install component that comes with the accessory kit.

Tighten the hose clamps.

Lubricate the O-ring.

Connect the connector.

Install the catch.

Installation

Use special tool: T9512955, Cover

Use special tool: T9512957, Coolant Reservoir

Fill with coolant and run the engine to operating temperature.

Post-fill the cooling system if necessary.

Reinstall the removed parts in reverse order.

Tightening torque: Aluminum wheel rim to wheel hub
Stage 1: 4 Nm
Stage 2: 50 Nm
Stage 3: 140 Nm