Information

• Read through all of the instructions before starting installation.

• Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

• Ensure that all tools stated in the instructions are available before starting installation.

• Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

• In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

Color symbols

1. Used for focused component, the component with which you will do something.

2. Used as extra colors when you need to show or differentiate additional parts.

3. Used for attachments that are to be removed/installed. May be screws, clips, connectors, etc.

4. Used when the component is not fully removed from the vehicle but only hung to the side.

5. Used for standard tools and special tools.

6. Used as background color for vehicle components.

7. Used for accessory components.

Removal

Remove the screw.

Tightening torque: Seat belt guide, to Bracket , 4.5 Nm

Remove the panel.

Remove the marked part.

Loosen the marked detail.

Repeat on the other side.

Remove the marked part.

Remove the marked part.

Remove the marked part.

Remove the marked detail/details.

Remove the screws.

Loosen the screws.

Remove the marked part.

Remove the marked part.

Disconnect the connector, if applicable.

Remove the panel.

Disconnect the connector.

Accessory installation

Disconnect the connector.

Install component that comes with the accessory kit.

Connect the connectors.

Position/route the wiring harness as illustrated.

Install the wiring harness.

Use a cable tie

Position/route the wiring harness as illustrated.

Install the wiring harness.

Use a cable tie

Connect the connector.

Position/route the wiring harness as illustrated.

Install the wiring harness.

Use a cable tie

Position/route the wiring harness as illustrated.

Install the wiring harness.

Use a cable tie

Install components that come with the accessory kit.

Vehicles without Suspension Module (SUM)

Install the marked components.

Use a cable tie

Vehicles with Suspension Module (SUM)

Clean the surface.

Use: , Isopropanol

Remove the protective film.

All vehicles

Connect the connector.

Reinstall the removed part.

Install component that comes with the accessory kit.

Make sure that the weather strip goes on top of the panel.

Use: Interior trim remover

Reinstall the screws.

Tighten the bolts.

Tightening torque: Luggage compartment sill moulding to body , 4.5 Nm

Install the marked components.

Connect the connector.

Remove the protective film.

Repeat on the other side.

Remove any traces of glue.

Använd en blandning av 50% Volvo koncentrerad spolarvätska och 50% vatten.

Repeat on the other side.

Installation

Reinstall the removed parts in reverse order.