Information

• Read through all of the instructions before starting installation.

• Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

• Ensure that all tools stated in the instructions are available before starting installation.

• Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

• In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

Color symbols

1. Used for focused component, the component with which you will do something.

2. Used as extra colors when you need to show or differentiate additional parts.

3. Used for attachments that are to be removed/installed. May be screws, clips, connectors, etc.

4. Used when the component is not fully removed from the vehicle but only hung to the side.

5. Used for standard tools and special tools.

6. Used as background color for vehicle components.

Removal

Set the ignition key to position 0.

Open the hood.

Remove the screws.

Fold the wing liner aside.

Accessory installation

Clean the Bumper Cover surface.

Take the template from the kit and cut it out following the dotted line.

Use tape

Removal

1. Remove the clips.

2. Remove the screws.

Fold the wing liner aside.

Accessory installation

Lubricate the O-ring.

Use: 1161761, Grease

Install the cable.

Removal

Place a container under the car.

Drain the coolant.

Accessory installation

Lubricate the O-ring.

Use: 1161761, Grease

Lubricate the O-ring.

Use: 1161761, Grease

Install the cable.

Installation

Fill with coolant and run the engine to operating temperature.

Vent the cooling system and check for leakage.

Post-fill the cooling system if necessary.

Reinstall the removed parts in reverse order.