Information

• Read through all of the instructions before starting installation.

• Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

• Ensure that all tools stated in the instructions are available before starting installation.

• Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

• In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

Removal

Tightening torque: Front seat to body , 40 Nm

Tightening torque: Front seat to body , 40 Nm

Alternative 1

Release the lock.

Alternative 2

Release the lock.

Repeat the steps when removing on opposite side.

Remove the panel.

Fold the carpet to the side.

1. Unhook the cable harness clips.

2. Disconnect the connector.

Remove the panel.

Vehicles with the 4C system.

Disconnect the connector.

All vehicles

Disconnect the connector.

Repeat on the other side.

Remove the screws.

Cars with automatic transmissions

Release the shift-lock function.

Cars with manual transmissions

Release the lock ring which is located inside the gear lever boot.

Pull the locking sleeve and gear lever boot down. Take care so that the boot does not come loose from the lock ring.

All vehicles

Disconnect the connectors.

Disconnect the connector, if applicable.

Attach the connector to the wiring harness.

Use: , Wiring tape

Remove the screws.

Disconnect the connector.

Use: Electrician's screwdriver

Repeat the steps when removing on opposite side.

Accessory installation

Use special tool: T9512932, Tension spring

Route the cable harness to the existing cable harness.

Secure the connectors.

Repeat the steps when installing accessories on opposite side.

Removal

Remove the panel.

Remove the weatherstrip.

Remove the screws.

Disconnect the connector.

Remove the screws.

Remove the screws.

Unhook the cable harness clips.

Disconnect the connector.

The part is not to be reused.

Accessory installation

Removal

Repeat on the other side.

Accessory installation

Tighten the bolts.

Tighten the bolts.

Route the cable harness to the existing cable harness.

Fold the carpet to the side.

Locate the connector.

Release the lock.

Disconnect the connector.

Use: Electrician's screwdriver

Connect the cable harness.

Connect the connectors.

Locate the connector.

Connect the cable harness.

Connect the connectors.

Connect the cable harness.

Removal

Vehicles with headset sockets

Disconnect the connector.

The part is not to be reused.

All vehicles

Vehicles with headset sockets

The part is not to be reused.

All vehicles

Disconnect the connectors.

Remove the screws.

Remove the screws.

Unhook the cable harness clips.

Remove the tape.

Reuse existing parts.

Alternative 1

Disconnect the connector.

Remove the cable harness clips.

Alternative 2

Remove the cable harness clips.

Disconnect the connector.

Remove the screws.

Accessory installation

Installation

Reinstall the screws.

Alternative 1

Alternative 2

Accessory installation

Connect the cable harness.

Remove the screw.

Connect the cable harness.

Reinstall the screw.

Tightening torque: M6 , 10 Nm

Reinstall the removed part.

Tightening torque: M6 , 10 Nm

Connect the cable harness.

Route the cable harness to the existing cable harness.

Fold the insulation to one side.

Fold the insulation to one side.

Installation

Connect the cable harness.

Connect the connector.

Tighten the screw.

Repeat the steps when installing on opposite side.

Reinstall the removed parts in reverse order.

Download software (application) for the accessory's function according to the service information in VIDA. See VIDA or the accessories catalogue for software part number.