Information

• Read through all of the instructions before starting installation.

• Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

• Ensure that all tools stated in the instructions are available before starting installation.

• Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

• In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

Conditions

When installing, the car must retain a temperature of 20 degrees C.

Color symbols

1. Used for focused component, the component with which you will do something.

2. Used as extra colors when you need to show or differentiate additional parts.

3. Used for attachments that are to be removed/installed. May be screws, clips, connectors, etc.

4. Used when the component is not fully removed from the vehicle but only hung to the side.

5. Used for standard tools and special tools.

6. Used as background color for vehicle components.

Removal

Set the ignition key to position 0.

Turn the wheel inwards.

Remove the screws.

Clean the Bumper Cover surface.

Use: , soap solution

Use the template in the installation instructions.

Cut following the dotted lines.

Secure the template with tape.

Adjust the hole with a file or knife as necessary.

Accessory installation

Removal

Remove the screws.

Fold the wing liner aside.

Accessory installation

Attach any excess wire to the wiring harness.

Removal

Place a container under the car.

Drain the coolant.

Loosen the clip.

Accessory installation

Installation

Install the clip(s).

Removal

Loosen the clip.

Remove the hose.

Remove the hose.

The part is not to be reused.

Accessory installation

Install the hose.

Tighten the hose clamps.

Install the hose.

Tighten the hose clamp.

Lubricate the O-ring.

Use: 1161761, Grease

Install the hose.

Tighten the hose clamp.

Connect the prerouted cable.

Install the catch.

Installation

Reinstall the removed parts in reverse order.

Fill with coolant and run the engine to operating temperature.

Vent the cooling system and check for leakage.

Post-fill the cooling system if necessary.