Information

• Read through all of the instructions before starting installation.

• Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

• Ensure that all tools stated in the instructions are available before starting installation.

• Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

• In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

Color symbols

1. Used for focused component, the component with which you will do something.

2. Used as extra colors when you need to show or differentiate additional parts.

3. Used for attachments that are to be removed/installed. May be screws, clips, connectors, etc.

4. Used when the component is not fully removed from the vehicle but only hung to the side.

5. Used for standard tools and special tools.

6. Used as background color for vehicle components.

Removal

Remove the panel.

Remove the panel.

Disconnect the connector.

Remove the panel.

Remove the screws.

Remove the panel.

Remove the screws.

Tightening torque: Front seat to body , 40 Nm

Remove the screws.

Tightening torque: Front seat to body , 40 Nm

Disconnect the connector.

Unhook the cable harness clips.

Remove the marked part.

Remove the battery's negative cable.

The graphic shows the back of the component.

Loosen the marked detail.

Disconnect the connectors.

Alternative 2

All vehicles

The part is not to be reused.

Release the lock.

Disconnect terminals from the connector, following the graphic.

The cable harness must not be reused.

Tape the cable terminal each for itself to avoid short-circuit.

Accessory installation

Connect the cable harness.

Install the catch.

Assemble components that come with the accessory kit.

Connect the connectors.

Use: 988734, Cable tie, 750 mm

Use: , Electrical tape

Pull the wiring through.

Install the cable.

Use a cable tie

Position/route the cable as illustrated.

Install the cable.

Use a cable tie

Position/route the cable as illustrated.

Install the cable.

Use a cable tie

Remove the nut.

Connect the prerouted cable.

Install the nut.

Tightening torque: M6 , 10 Nm

Position/route the cable as illustrated.

Install the cable.

Use a cable tie

Remove the marked part.

Release the connector's catch.

Depress the locking device.

Remove the marked part.

Connect the cable.

Install component that comes with the accessory kit.

On some vehicles fuse might be premounted.

Install the marked component.

Download software (application) for the accessory's function according to the service information in VIDA. See VIDA or the accessories catalogue for software part number.

First, download the software for USB, then Smartphone Integration.

Installation

Reinstall the removed parts in reverse order.