Information

• Read through all of the instructions before starting installation.

• Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

• Ensure that all tools stated in the instructions are available before starting installation.

• Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

• In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

Conditions

Set the ignition key to position 0.

Remove the battery's negative cable.

Color symbols

1. Used for focused component, the component with which you will do something.

2. Used as extra colors when you need to show or differentiate additional parts.

3. Used for attachments that are to be removed/installed. May be screws, clips, connectors, etc.

4. Used when the component is not fully removed from the vehicle but only hung to the side.

5. Used for standard tools and special tools.

6. Used as background color for vehicle components.

Removal

Remove the panel.

Remove the panel.

Remove the weatherstrip.

Remove the panel.

Remove the panel.

Remove the screws.

Remove the screws.

Cars with manual transmissions

Release the catch which is located inside the gear lever boot.

Cars with automatic transmissions

Release the shift-lock function.

Move the gear lever to D.

All vehicles

Remove the panel.

Remove the panel.

1. Fold the carpet to the side.

2. Unhook the clip(s).

3. Disconnect the connector.

Remove the screws.

Remove the panel.

Vehicles with the 4C system.

Disconnect the connector.

All vehicles

Remove the panel.

Remove the screws.

Detach the panel.

Accessory installation

Removal

Remove the screws.

Disconnect the connectors.

Remove the screws.

Remove the panel.

Remove the panel.

Remove the screws.

On both sides.

Remove the panel.

Remove the screws.

Detach the panel.

Disconnect the connector.

Accessory installation

Facilitate cable routing by temporarily raising the floor bracket using a socket or similar.

Pull the wiring through.

Connect the connectors.

Tear off the excess foam tape.

Route the cable harness to the existing cable harness.

Route the cable harness to the existing cable harness.

Pull the wiring through.

Install the cable.

Connect the prerouted cable.

Installation

Connect the connectors.

Install the screws.

Removal

Fold the carpet to the side.

Locate the rubber grommet under the insulation and press it out.

Accessory installation

Route the cable harness to the existing cable harness.

Pull the wiring through.

Removal

Remove the screws.

Remove the clips.

Accessory installation

Pull the wiring through.

Use: 1161427, Low temperature grease

Removal

Release the catches.

Disconnect the connector.

Remove the nuts.

Accessory installation

Pull the wiring through.

Route the cable harness to the existing cable harness.

Route the cable harness to the existing cable harness.

Insert the cable in to the passenger compartment, adjust the cable length out into the engine compartment and secure the rubber grommet.

Removal

Locate relevant marking.

Accessory installation

Connect the connector.

Reinstall the removed parts in reverse order.

Reinstall the battery's negative cable.

Download software (application) for the accessory's function according to the service information in VIDA.

Order and download software according to: 31288598