• Open the boot lid.

• Lift up the cargo compartment's divider.

• Remove the covers on each side of the divider.

• Screw out the two nuts 4 revolutions, on each side of the divider.

• Lower the divider slightly.

• Unscrew the third nut on each side of the divider four turns.

• Lower the divider completely.

• Detach the wire frame from the clip.

• Use a cable tie or the like to lock the divider's two arms on the right and left side.

• Remove the divider by gripping the arms and lifting up.

Remove:

• the toolbox cover.

• the spare wheel, if present.

• Take the tools out from the toolbox.

Remove:

• the clip.

• the screw.

• the toolbox.

• Remove the three screws and the load retaining eyelets from the floor.

• Remove the cover from the trunk lid stop. Use a weatherstrip tool to pry between the cover and the stop to release the catches.

• Remove the two lamps by pressing in the two catches in the top edge using a screwdriver.

Applies to cars with emergency opening handle in the cargo compartment

• Remove the boot lid's emergency opening handle by pressing out the pin at the eye and then unhooking the wire.

• Remove the two screws in the sill moulding.

• Remove the sill moulding by pulling it up until the clips release. Move the sill moulding to one side.

• Remove the carpet in the cargo compartment.

• Remove the rubber stop on the roof's stop bracket.

• Mark out the stop bracket for the roof in relation to the screw.

• Remove the screw and the roof's stop bracket.

• Remove the load divider lock by using a weatherstrip tool to pry between the carpet and lock.

• Remove the screw and the load retaining eyelet on the right-hand side.

• Remove the stop brace cover.

• Mark out the stop braces for the roof in relation to the screws and nuts on the right side.

• Remove the screw, nut and the roof's stop braces.

• Undo the four clips on the side panel.

• Remove the side panel by unhooking it from the stop lug at the front edge and the pulling outward and upward so that it releases from the sealing strip.

• Remove the nuts.

• Remove the screw.

Installing the control module

• Clean the marked surface on the inside of the bracket using isopropanol and wipe dry.

  Use: Isopropanol, 1161721

Use: Isopropanol, 1161721 Wipe dry.

When installing Velcro tape the surface must maintain a temperature of at least +20 ° C (68°F).

• Press the control module against the bracket.

• Connect the connector from the wiring to the control module.

• Locate the 2-pin gray connector that is taped to the vehicle's standard cable harness.

Applies to cars with parking assistance

• Locate the 4-pin green connector that is taped to the cable harness for park assist.

Applies to cars with accessory electronic modules (AEM)

• Locate the 4-pin green connector from the accessory electronic module (AEM) taped to the vehicle's standard cable harness.

Applies to others

• Locate the 4-pin green connector that is taped to the vehicle's standard cable harness.

• Connect the extension cable to the located connector.

• Connect the connectors from the extension wiring to the control module.

Applies to cars from chassis number 40000-

• Pull up the catch on the cover on the fuse box in the engine compartment. Pull up the cover and remove it.

• Install a 40A fuse in position 14.

  
  

  Note! This fuse included in the TRM kit must NOT be used.

  
  

• Reinstall the cover.

Applies to all models

• Reinstall the detached components in reverse order.

• Download the software (application) for the accessory's function following the service information in VIDA.

  See VIDA or the accessories catalogue for software part number.