Information

• Read through all of the instructions before starting installation.

• Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

• Ensure that all tools stated in the instructions are available before starting installation.

• Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

• In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

Conditions

After installation, the car must not be driven for 2 hours

After installation, the car must not be washed for 48 hours

When installing, the car must retain a temperature of 20 degrees C.

Vehicles with Skidplate

All vehicles

Use: 1161721, Isopropanol

Matt the surface gently.

Use: , Sand paper P1000

Use: 1161721, Isopropanol

Do not touch the surface.

Use: , Volvo Original Touch-up paint

Use base coat only.

Use: 31335447, Varnish 2-component

Also see the instructions on the container.

Set the ignition key to position 0.

Fold the carpet to the side.

Remove the cable harness clips.

Disconnect the connector.

Vehicles with the 4C system.

All vehicles

Remove the screws.

Remove the screws.

Cars with automatic transmissions

Release the shift-lock function.

Move the gear lever to D.

Cars with manual transmissions

Release the lock ring which is located inside the gear lever boot.

Pull the locking sleeve and gear lever boot down. Take care so that the boot does not come loose from the lock ring.

Release the lock.

All vehicles

Remove the screws.

Reinstall the removed parts in reverse order.

Removal

Repeat the steps when removing on opposite side.

Vehicles with keyless entry

All vehicles

Locate the markings for the positions.

Use special tool: T9997234, Hole stamp

Clean the surfaces.

Allow to dry.

Use: 1161721, Isopropanol

Clean the surface.

Allow to dry.

Use: 1161721, Isopropanol

Clean the surface.

Allow to dry.

Use: 1161721, Isopropanol

Apply a thin and even layer.

Allow to dry for at least 10 minutes.

Use: 8637076, Activator

Apply a thin and even layer.

Allow to dry for at least 10 minutes.

Use: 8637076, Activator

Apply a thin and even layer.

Allow to dry for at least 10 minutes.

Use: 8637076, Activator

Release the lock.

Repeat on the other side.

Remove the screw.

Remove the screws.

Remove the screws.

Remove the screws.

Tightening torque: M8 , 24 Nm

Vehicles with keyless entry

Locate the connector.

Disconnect the connector.

Unhook the clip(s).

The part is not to be reused.

Vehicles without keyless entry

All vehicles

Vehicles without keyless entry

Tear off the excess foam tape.

Vehicles with keyless entry

All vehicles

Locate the existing connector in the vehicle's cable harness.

Installation

Note position of components.

Repeat method steps for installing.

Put the wiring in the Bumper cover without installing the wiring.

Connect the two painted sensors to the external connections.

Vehicles without keyless entry

Tear off the excess foam tape.

Vehicles with keyless entry

All vehicles

Reinstall the removed parts in reverse order.

Download software (application) for the accessory's function according to the service information in VIDA. See VIDA or the accessories catalogue for software part number.