Information

• Read through all of the instructions before starting installation.

• Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

• Ensure that all tools stated in the instructions are available before starting installation.

• Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

• In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

Color symbols

1. Used for focused component, the component with which you will do something.

2. Used as extra colors when you need to show or differentiate additional parts.

3. Used for attachments that are to be removed/installed. May be screws, clips, connectors, etc.

4. Used when the component is not fully removed from the vehicle but only hung to the side.

5. Used for standard tools and special tools.

6. Used as background color for vehicle components.

Further information

There may be parts in the accessories kit that are not needed for this installation.

Removal

Set the ignition key to position 0.

Remove the panel.

Remove the screw.

Release the lock.

Remove the panel.

Remove the part carefully

Remove the screws.

Disconnect the connectors.

Remove the screws.

The part is to be reused.

Disconnect the connectors.

Repeat on the other side.

Vehicles with heated rear seat

Locate the connector.

Disconnect the connector.

Repeat on the other side.

All vehicles

Remove the panel.

Remove the panel.

Detach the panel.

Detach the panel.

Repeat on the other side.

Remove the screws.

Remove the panel.

Detach the panel.

Disconnect the connector.

Remove the panel.

Remove the panel.

Remove the nuts.

Accessory installation

Locate the connector.

Connect the connector.

Route the cable harness to the existing cable harness.

Fold the carpet aside.

Route the cable harness to the existing cable harness.

Fold the carpet aside.

Use special tool: T9512932, Tension spring

Fold the carpet aside.

Route the cable harness to the existing cable harness.

Use special tool: T9512932, Tension spring

Pull the wiring through.

Installation

Connect the connector.

Connect the connectors.

Reinstall the screws.

Reinstall the removed parts in reverse order.

Removal

Remove the screws.

Remove the panel.

Remove the panel.

Remove the panel.

Remove the screw.

On both sides.

Remove the screws.

Carefully pry loose the bottom edge of the panel and then continue around the panel.

Disconnect the connector.

Remove the panel.

Remove the nut.

Use special tool: T9814088, Puller

Disconnect the connector.

Disconnect the connector.

Disconnect the connector.

Remove the screws.

Remove the nuts.

Remove the panel.

Accessory installation

Install the panel.

Install the nuts

Tightening torque: M6 , 10 Nm

Install the screws.

Tightening torque: M6 , 10 Nm

Connect the connector.

Connect the connector.

Connect the connector.

Reinstall the removed parts in reverse order.

Release the catches.

Install component that comes with the accessory kit.

Reinstall the removed parts in reverse order.

Download software (application) for the accessory's function according to the service information in VIDA. See VIDA or the accessories catalogue for software part number.

Order and download software according to: 31330702