Information

• Read through all of the instructions before starting installation.

• Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

• Ensure that all tools stated in the instructions are available before starting installation.

• Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

• In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

Color symbols

1. Used for focused component, the component with which you will do something.

2. Used as extra colors when you need to show or differentiate additional parts.

3. Used for attachments that are to be removed/installed. May be screws, clips, connectors, etc.

4. Used when the component is not fully removed from the vehicle but only hung to the side.

5. Used for standard tools and special tools.

6. Used as background color for vehicle components.

Removal

Release the connector's catch.

Disconnect the connector.

Loosen the screws.

Lift the marked component up

Lift the marked component up

Remove the marked part.

The part is not to be reused.

Accessory installation

Install component that comes with the accessory kit.

Reinstall the removed part.

Tighten the bolts.

Connect the connector.

Clean the surface.

Use: , Isopropanol

Install component that comes with the accessory kit.

Removal

Remove the marked part.

Locate relevant marking.

Use: Pipe cutter

Remove the nuts.

Remove the marked part.

Remove the marked part.

The part is not to be reused.

Remove the marked part.

Remove the marked part.

Remove the screws.

Applies to V60 models

All vehicles

Remove the screws.

On both sides.

Request the aid of a colleague for this procedure.

Vehicles with parking assistance

Disconnect the connectors.

On both sides.

Remove the marked part.

On both sides.

Disconnect the connector.

Loosen the clips.

Vehicles with integrated Exhaust End Pipes

Remove the screws.

On both sides.

Remove the clips.

On both sides.

Remove the marked part.

Remove the marked part.

All vehicles

Remove the marked part.

Accessory installation

Install component that comes with the accessory kit.

Vehicles with towbar

Cut the component following the instructions in the graphic.

Vehicles with parking assistance

Reinstall the removed part.

Remove the clip.

The part is not to be reused.

Install component that comes with the accessory kit.

Install component that comes with the accessory kit.

Install the clips as illustrated.

Install component that comes with the accessory kit.

Connect the connectors.

Position/route the cable harness as illustrated.

Place the Bumper Cover in position for installation.

Connect the connector.

All vehicles

Applies to V60 models

All vehicles

Install the screws.

On both sides.

Install the screws.

Install component that comes with the accessory kit.

Tightening torque: M8 , 24 Nm

Tighten the bolts.

Install component that comes with the accessory kit.

Install component that comes with the accessory kit.

Install component that comes with the accessory kit.

Install component that comes with the accessory kit.

Tighten the nuts.

Tightening torque: M8 , 24 Nm

Install component that comes with the accessory kit.

Tighten the nut.

Tightening torque: Exhaust clamp , 60 Nm

Install component that comes with the accessory kit.

Tighten the nut.

Tightening torque: Exhaust clamp , 60 Nm

Install component that comes with the accessory kit.

Install component that comes with the accessory kit.

Install component that comes with the accessory kit.

Adjust to the specified value.

On both sides.

Tightening torque: M8 , 24 Nm

Adjust to the specified value.

On both sides.

Tightening torque: End pipe, to Muffler (Allen screw) , 5 Nm

On both sides.