2007 R AWD L.H.D

Installation Instructions

Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
V70 2007
V70 (00-08) 2007

Instruction NoVersionPart. No.Click to download PDF-version of this Installation Instruction
307677551.0
Child seat, Isofix mounting, rear




M8802390




Equipment
A0000162
IMG-239664

M8802389

IMG-213320


 
  

INTRODUCTION

  • Read through all of the instructions before starting installation.

  • Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

  • Ensure that all tools stated in the instructions are available before starting installation.

  • Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

  • In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

 

Note!

It is recommended that an authorized Volvo workshop carries out the installation of this accessory.



Note!

For the S80, the installation instruction only applies to cars from and including week 20, year 2000.


1
 

    Applies to the V70 (00-)

  • Fold up the rear seat cushion.

    Applies to the S60 and S80

  • Detach and lift out the rear seat cushion.

2
IMG-264323
 

  • Fold the insulation mat on the right-hand side to one side.

3
IMG-264324
 

  • Tape the insulation mat (1) as illustrated.

4A
M8802415
4B
M8802416
 

Image A applies to the installation of ISOFIX on the side where the seat belt's single buckle is located.

Image B applies to the installation of ISOFIX on the side of the car where the seat belt's double buckle is located.


Note!

The S80 has the opposite seat belt geometry to the V70 (00-), i.e. the seat belt's double buckle is located on the opposite side.


    Carry out on both sides

  • Remove the screw (1). For the single buckle - remove the middle seat belt's end mounting (2).

  • Replace the screw (1) with a new screw from the kit.

  • Expose the existing stud (5) by removing the perforated part of the insulation under the ISOFIX bracket (3).

  • Position the ISOFIX bracket (3) as illustrated.

  • Install the screw (1). For the single buckle - together with the middle seat belt's end mounting (2).

  • Install nut (4) and washer (6), from the kit.

  • Tighten the screw (1) to 40 Nm (30 lbf.ft.) and then tighten nut (4) to 30 Nm (22 lbf.ft.).

5
 

    Applies to the V70 (00-)

  • Fold the rear seat cushion back into place.

    Applies to the S60 and S80

  • Reinstall the rear seat cushion.