Gear selector lever boot - V70 2007 R AWD

INTRODUCTION

Read through all of the instructions before starting installation.
Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.
Ensure that all tools stated in the instructions are available before starting installation.
Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.
In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

M4303591

Pry off the rear edge of the gear selector lever cover together with the boot until the two clips release. Use a plastic weatherstrip tool. Remove the gear selector lever cover and the boot
Then pull the panel up until the four clips at the sides release.

M4303585

Lift the boot up over the gear selector lever to access the locking sleeve
Press in the two catches on the locking sleeve. Pull the locking sleeve downwards.

M4303586

M4302426

Pull apart the support ring on the gear selector lever slightly. Pull the support ring straight up. Remove the support ring.

M4303587

M4303592

M4303588

M4303589

Reinstall the support ring on the gear selector lever
Take the gear selector lever knob. Ensure that the support ring is straight in its groove in the gear selector lever
Press the knob down over the support ring so that it locks.

M4303590

Pull up the panel with the boot towards the gear selector lever knob
Pull the locking sleeve up to the gear selector lever knob. Turn the locking sleeve slightly so that the guide (1) inside the locking sleeve is correctly positioned on the notch (2) on the gear selector lever knob
Pull the locking sleeve until it locks. Check that the locking sleeve is securely mounted on the gear selector lever knob. Pull the gear selector lever knob to check that it is securely mounted
Lower the panel. Press the panel into place in the centre console.

Installation Instructions