2007 R AWD L.H.D

Installation Instructions

Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
V70 2007
V70 (00-08) 2007

Instruction NoVersionPart. No.Click to download PDF-version of this Installation Instruction
86901651.0
Wind surfer holder, T-grooves





M8902780





 
  

INTRODUCTION

  • Read through all of the instructions before starting installation.

  • Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

  • Ensure that all tools stated in the instructions are available before starting installation.

  • Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

  • In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

  

Note!

Important

Regularly check that the load carriers are properly secured

The maximum roof load is 100 kg

Distribute the load evenly over the load carriers. Do not load at an angle!

Position the heaviest load underneath

Remove the load carriers when not in use. Air resistance is thus reduced which improves fuel consumption and reduces wind noise

Handling is affected by the actual load and its position. The centre of gravity of the car changes when driving with a load, which affects the handling of the car. Adjust speed accordingly. For further information refer to the manual.


 

Securing the wind surfer holder on the wing profile load carriers

1
M8902781
 

Securing the wind surfer holder on the wing profile load carriers

  • Remove the cover on the load carriers

  • Remove the rubber seal for the T-grooves

  • Slide on the wind surfer holder in the T-groove to the desired position.

2
M8902782
 

  • Take the mast holder and position the latch on the horizontal position

  • Slide on the mast holder in the T-groove to the desired position

  • Twist the latch upwards to the vertical limit position

  • Reinstall the cover.

3
M8902810
 

  • Measure and cut-out and reinstall the T-groove seals so that they cover the sections of the T-grooves which are not covered by the holders. This is to reduce wind noise.

 

Securing the wind surfer holder on the oval profile load carriers

4
M8902783
 

Securing the wind surfer holder on the oval profile load carriers

  • Fold out the cover on the end of the load carriers.

  • Remove the rubber seal for the T-grooves

  • Slide on the wind surfer holder in the T-groove to the desired position.

5
M8902784
 

  • Take the mast holder and position the latch on the horizontal position

  • Slide on the mast holder in the T-groove to the desired position

  • Twist the latch upwards to the vertical limit position

  • Fold the cover back into place.

6
M8902810
 

  • Measure and cut-out and reinstall the T-groove seals so that they cover the sections of the T-grooves which are not covered by the holders. This is to reduce wind noise.

7
M8902785
 

Securing the wind surfer board with the mast on the car as illustrated.

© Volvo Car CorporationWind surfer holder, T-grooves- 8690165 - V1.0
volvocars.com
Lifestyle Collection
Español
Find a Dealer
United States

Cookies Legal Disclaimer Privacy Policy Copyright

Copyright © 2024 Volvo Cars. All rights reserved.