Information

• Read through all of the instructions before starting installation.

• Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

• Ensure that all tools stated in the instructions are available before starting installation.

• Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

• In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

Removal

Remove the nuts.

Vehicles with Skidplate

Vehicles with R-design

Remove the clips.

Repeat on the other side.

All vehicles

Remove the screws.

Repeat on the other side.

Remove the screws.

Alternative 1

Remove the screws.

Alternative 2

Applies to vehicles with single end pipe

Applies to vehicles with double end pipe

All vehicles

Remove the screws.

Remove the clips.

Remove the tape.

Repeat on the other side.

Clean the surface.

Repeat on the other side.

Accessory installation

Repeat on the other side.

Install the screws.

Repeat on the other side.

Use special tool: T9995972, FIXTURE (UNIVERSAL/TRANSAXLES)

Use special tool: T9985972, JACK (HYDRAULIC)

Repeat on the other side.

Repeat on the other side.

Use special tool: T9997338, Extension rod

Installation

Reinstall the clips.

Use: 9510228, Stone-chip protection

Alternative 1

Reinstall the screws.

Alternative 2

All vehicles

Reinstall the screws.

Applies to vehicles with double end pipe

Applies to vehicles with single end pipe

All vehicles

Install tow bar connector and wiring harness according to installation instruction: Towbar, Wiring and Control Unit.

Use: , Rust inhibitor, low viscosity

Repeat on the other side.

Use: , Rust inhibitor, low viscosity

Repeat on the other side.

Install the screws.

Accessory installation

Locate relevant marking.

Apply tape to the other side, opposite the marking lines.

Deburr edges

Vehicles with Skidplate

Locate relevant marking.

Deburr edges

Locate relevant marking.

Apply tape to the other side, opposite the marking lines.

Deburr edges

Vehicles with R-design

Locate relevant marking.

Deburr edges

Locate relevant marking.

Apply tape to the other side, opposite the marking lines.

Deburr edges

Clean the Bumper Cover surface.

Wipe dry.

Use: 1161721, Isopropanol

Allow to dry.

Use: 1161815, Stone-chip protection

All vehicles

Install the screws.

Repeat on the other side.

Vehicles with Skidplate

Vehicles with R-design

Repeat on the other side.

All vehicles

Install the nuts

Alternative 1

Take the label from the kit and attach it to the underneath of the cargo compartment mat as illustrated.

Alternative 2

Take the label from the kit and attach it to the underneath of the cargo compartment mat as illustrated.

Attach the four corners of the label using staples.

All vehicles