Skid plate, front bumper - C30 2011 - Volvo Cars Accessories

Installation instructions, accessories

Volvo Car Corporation Gothenburg, Sweden

C30 2011

Instruction No		Version		Part. No.
31373896		1.2		30758018, 30758017, 30758016, 30758015, 31330004, 31330003, 31265611

Skid plate, front bumper

IMG-332065

Equipment

A0000162

IMG-239940

IMG-239660

IMG-239681

A0000177

A0000214

M0000232

IMG-332068

INTRODUCTION

Read through all of the instructions before starting installation.
Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.
Ensure that all tools stated in the instructions are available before starting installation.
Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.
In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

Note!

Carry out the work at a temperature of at least 20 °C (68 °F).

Do not use the vehicle within 2 hours after doing the work.

Do not wash the vehicle within 48 hours after doing the work.

IMG-332072

Wash the surfaces of the car that are to be covered by the skid plate.
Wipe dry.

IMG-332084

Remove the two centre screws from the air baffle. They will not be reused.

IMG-332085

Take the drilling template and skid plate from the kit and press the drilling template into the hole in the mounting lug to the clip's mounting.
Repeat the operation on the other side.

IMG-332086

Remove the backing tape from both templates.

IMG-332087

Secure the skid plate using existing screws. Do not tighten excessively so that the position can be adjusted laterally. Ensure that the tape on the drilling template does not adhere yet.

IMG-332089

Now position the skid plate laterally (1). Ensure that the tape on the drilling templates does not adhere yet.

Note!

Push the ends (2) of the skid plate up from underneath as far as possible, and then press in front of the drilling templates (3) so that the tape adheres.

IMG-332092

Remove the skid plate from the grille.

IMG-332093

Drill out the holes through the taped drilling templates.

IMG-332094

Remove the drilling templates on both sides.

IMG-332095

Drill the holes to Ø 8 mm (5/16 ").
Remove the swarf and smooth off the hole edges.

IMG-332096

Take the clip from the kit and take the skid plate again.
Insert one spike on the clip under the edge of the hole in the skid plate, turn clockwise and at the same time press until the clip is in place.
Repeat the operation on the other side.

12A

IMG-332098

12B

IMG-332212

Illustrations A and B

Now carefully pull off the protective tape slightly from each piece of tape on both sides and secure on the upper side/outside using pieces of tape on both sides of the skid plate.