Information

• Read through all of the instructions before starting installation.

• Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

• Ensure that all tools stated in the instructions are available before starting installation.

• Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

• In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

There may be parts in the accessories kit that are not needed for this installation.

Color symbols

1. Used for focused component, the component with which you will do something.

2. Used as extra colors when you need to show or differentiate additional parts.

3. Used for attachments that are to be removed/installed. May be screws, clips, connectors, etc.

4. Used when the component is not fully removed from the vehicle but only hung to the side.

5. Used for standard tools and special tools.

6. Used as background color for vehicle components.

Removal

Set the ignition key to position 0.

Open the hood.

Remove the screws.

Remove the nut.

Fold the wing liner to one side.

Accessory installation

Clean the Bumper Cover surface.

Take the template from the kit and cut it out following the dotted line.

Use tape

All vehicles

Note! Ensure that the protective cover is turned the right way.

Removal

Raise the car.

1. Remove the clips.

2. Remove the screws.

Loosen the hose clamp.

The part is to be reused.

Vehicles with diesel engines

All vehicles

Remove the screw.

The part is to be reused.

Remove the nut.

The part is to be reused.

Remove the part carefully

Fold the wing liner to one side.

Place a container under the car.

Drain the coolant.

Accessory installation

Install the screw.

Install the clip(s).

Tighten the cable ties.

Install the clip(s).

Tighten the cable ties.

Tighten the cable tie.

Tighten the cable tie.

Loosen the hose clamp.

The part is to be reused.

Install the screw.

Tightening torque: M6 , 10 Nm

Tighten the hose clamps.

Remove the nut.

The part is to be reused.

Install the nut.

Tightening torque: M8 , 24 Nm

Tighten the hose clamp.

Install the clip(s).

Tighten the cable tie.

Install the clip(s).

Tighten the cable tie.

Remove any excess.

Clamp using the grey cable tie.

Install the clip(s).

Clamp using the grey cable tie.

Lubricate the O-ring.

Use: 1161427, Low temperature grease

Connect the connector.

Install the catch.

Installation

Fill with coolant and run the engine to operating temperature.

Vent the cooling system and check for leakage.

Post-fill the cooling system if necessary.

Reinstall the removed parts in reverse order.