Applies to all models
Wait at least three minutes before unplugging the connectors or removing other electrical equipment.
Fold the central arm rest forward.
Remove the central arm rest by grasping each end and pulling upwards until it releases at the rear edge from the backrest's lugs (1).
Then pull forwards until the holders (2) on the sides of the backrest have slid out of the corresponding cut-out (3) in the central arm rest.
The backrest may be securely attached.
Unhook the safety clip from the panel.
Angle out the panel at the lower edge, and unhook it at the upper edge so that the upper clip releases.
Remove the screw from the right-hand panel in the rear seat.
Carefully pull the panel from the body side and unhook it from the sill panel at the front edge. It is secured by eleven clips on the inside.
Remove the clips at the rear edge on the right-hand rear side panel.
Carefully pull the side panel off, starting at the front edge of the upper edge and then straight back until all clips at the top edge have released.
Fold the panel inwards. Release it from the anchorage eyelets and lift it out of the spare wheel well.
Applies to cars without a trailer module (TRM) and Parking assistance (PAS)
Applies to cars with a trailer module (TRM)
Applies to cars with parking assistance (PAS) without trailer module (TRM)
It is important that parking assistance (PAS) is connected the same way as the first unit.
A and B
Position the control module along the rear edge of the rectangular storage compartment in the spare wheel well (dotted line 1).
Position the control module vertically with the lower panel edge on the wheel housing (dotted line 2).
Press the control module into place properly.
Applies to cars with chassis numbers from 39000->