Take the cradle from the kit.
Drill nine holes using a Ø5 mm (3/16") drill bit, in the centre of the drill markings (the countersunk holes) on the cradle.
Remove any swarf. Clean the edges of the holes.
Illustrations A and B
Position the cradle with the fixtures as illustrated. The fixtures must be secured at the upper edge of the upper hole on the lower grille.
Do not tighten the cradle yet.
Loosely secure the cradle on both sides. Ensure that the edge of the cradle is in line with the line in the bumper cover on both sides.
It is important that the cradle is properly in the hole against the upper edge of the grille so that positioning is correct.
Press the entire cradle securely.
It is important that the cradle is secured along its entire length, so that no bulges occur when attaching.
Place the panel on top of the cradle with the hooks opposite the corresponding cut-out in the panel, and angled 30 mm (1 3/16") at the lower edge.
Press the panel (1) so that the hooks engage, a click should be heard.
Align the panel (2) against the bumper cover.
Ensure that it is secure, all hooks must be engaged.