Information

• Read through all of the instructions before starting installation.

• Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

• Ensure that all tools stated in the instructions are available before starting installation.

• Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

• In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

This instruction covers a Plug-In Hybride vehicle.

This car is equipped with a high voltage type electrical system.

Components in the high voltage system work with dangerous voltages.

These components are connected with orange wires.

Color symbols

1. Used for focused component, the component with which you will do something.

2. Used as extra colors when you need to show or differentiate additional parts.

3. Used for attachments that are to be removed/installed. May be screws, clips, connectors, etc.

4. Used when the component is not fully removed from the vehicle but only hung to the side.

5. Used for standard tools and special tools.

6. Used as background color for vehicle components.

Removal

Set the ignition key to position 0.

Remove the panel.

Fold the carpet aside.

Remove the cable harness clips.

Disconnect the connector.

Remove the panel.

Disconnect the connector.

Carefully pry loose the bottom edge of the panel and then continue around the panel.

Disconnect the connector.

Remove the screws.

Remove the screws.

Cars with automatic transmissions

Release the shift-lock function.

All vehicles

Cars with manual transmissions

All vehicles

Disconnect the connector.

Remove the screws.

Accessory installation

Install component that comes with the accessory kit.

Installation

Reinstall the screws.

Removal

Remove the screws.

Disconnect the connectors.

Remove the screws.

Remove the screws.

Remove the panel.

Detach the panel.

Disconnect the connector.

Accessory installation

Install component that comes with the accessory kit.

Locate the existing connector in the vehicle's cable harness.

Connect the connector.

Tear off the excess foam tape.

Clamp the cables and connectors to the existing cables to prevent noise.

Pull the wiring through.

Connect the prerouted cable.

Connect the connectors.

Fold the carpet aside.

Locate the rubber grommet under the insulating mat.

The part is not to be reused.

Pull the wiring through.

Fold the floor carpet back.

Installation

Reinstall the removed parts in reverse order.

Removal

Place the tape so that it enters under the grille edge, protecting the painted area when removing the grille.

Use: , Electrical tape

Use special tool: T9997390, Key

Pull the grille outwards with one hand and keep it there while undoing the next retainer hook.

Remove the nuts.

Accessory installation

Fold the insulation aside.

Use special tool: T9512932, Tension spring

Raise the car.

Remove the clips.

Remove the screws.

Remove the clip.

Remove the screws.

Use: Expander pliers

Use: 1161427, Low temperature grease

Use: , Electrical tape

Pull the wiring through.

Pull the wiring through.

Remove the Special Tool.

Route the cable harness to the existing cable harness.

Route the cable harness to the existing cable harness.

Route the cable harness to the existing cable harness.

Pull the wiring through.

Tighten the cable ties.

Remove the tape.

Remove any traces of glue.

Use: , Isopropanol

Use: Angle drill machine

Use special tool: T9997482, Cutting tool

Use special tool: T9997482, Cutting tool

Use: Angle drill machine

Use special tool: T9997482, Cutting tool

Connect the connector.

Reinstall the removed part.

Reinstall the removed parts in reverse order.

Download software (application) for the accessory's function according to the service information in VIDA. See VIDA or the accessories catalogue for software part number.

Order and download software according to: 31285245