Information

• Read through all of the instructions before starting installation.

• Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

• Ensure that all tools stated in the instructions are available before starting installation.

• Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

• In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

Further information

There may be parts in the accessories kit that are not needed for this installation.

Color symbols

1. Used for focused component, the component with which you will do something.

2. Used as extra colors when you need to show or differentiate additional parts.

3. Used for attachments that are to be removed/installed. May be screws, clips, connectors, etc.

4. Used when the component is not fully removed from the vehicle but only hung to the side.

5. Used for standard tools and special tools.

6. Used as background color for vehicle components.

Removal

Remove the screw.

Remove the panel.

Detach the panel.

Release the catches.

Remove the panel.

Use special tool: T9995919, PULLER (SEAL-PINION,CAM-CRANKSHAFT)B200-6304

Remove the screws.

Tightening torque: M8 , 24 Nm

Loosen the screws.

Remove the panel.

Detach the panel.

Remove the panel.

Locate relevant marking.

Measure and mark out the centre.

Prepare the hole diameter.

Install component that comes with the accessory kit.

Remove the clips.

Fold the insulation aside.

Locate and disconnect the 2-pin connector that is taped to the car's cable harness.

Pull the wiring through.

Refit the insulation.

Reinstall the clips.

Reinstall the removed part.

Connect the connector.

Reinstall the removed parts in reverse order.