Protective plate, beneath the engine - S80 2011

Installation instructions, accessories

Volvo Car Corporation Gothenburg, Sweden

S80 2011

S80 (07-) 2011

Instruction No		Version		Part. No.
31316527		1.5		31370000, 31316732, 31316517

Protective plate, beneath the engine

IMG-304503

Equipment

A0000162

IMG-304663

IMG-239664

IMG-239660

IMG-304523

IMG-340412

INTRODUCTION

Read through all of the instructions before starting installation.
Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.
Ensure that all tools stated in the instructions are available before starting installation.
Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.
In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

IMG-340317

Applies to the S60(11-)

IMG-231309

Applies to all models

IMG-304563

IMG-304564

Cover the underneath of the engine with cardboard or similar, so that drilling swarf does not blow up into the engine compartment.
Carefully drill out the rectangular holes where the clips were located. Use tool P/N 9814112.
Remove any swarf.

IMG-304565

Take the rivet nuts from the kit and tighten in the drilled holes. Use tool P/N 9512782.

IMG-304583

Take the new protective plate with screws and spacers from the kit.
Position the protective plate so that the high spacers with the longer screws are at the back, and the four low spacers with the shorter screws at the sides are at the front.
Secure the spacers on the protective plate opposite the holes using pieces of butyl tape.

IMG-340413

Note!

Get help from a colleague for this procedure.

Lift the protective plate into position.
Install the screws. Position the long screws are the back. Tighten them to 30 Nm (22 lbf.ft.).
Slacken the screws two turns.
Tighten the screws. Tighten to 24 Nm (18 lbf. ft.).

IMG-340318

Applies to the S60(11-)

Installation Instruction