Information

• Read through all of the instructions before starting installation.

• Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

• Ensure that all tools stated in the instructions are available before starting installation.

• Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

• In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

Color symbols

1. Used for focused component, the component with which you will do something.

2. Used as extra colors when you need to show or differentiate additional parts.

3. Used for attachments that are to be removed/installed. May be screws, clips, connectors, etc.

4. Used when the component is not fully removed from the vehicle but only hung to the side.

5. Used for standard tools and special tools.

6. Used as background color for vehicle components.

Preparation

Set the ignition key to position 0.

Wait for about 2 minutes until the vehicle has gone to sleep-mode.

Removal

Remove the screws.

Remove the screws.

1. Release the connector's catch.

2. Disconnect the connector.

3. Remove the screw.

Remove the screws.

Remove the rubber strip.

Release the catches.

Detach the panel.

Remove all clips (8 pcs on each side) from the door sill, and in the front and rear wings, and replace them with new ones.

Accessory installation

Install the clips as illustrated.

Note position of components.

Note the position.

Reinstall the rubber weatherstrip.

Install the nut.

Note the position.

Use special tool: T9512782, Rivet nut tool

1. Install component that comes with the accessory kit.

2. Install the screws.

3. 
   

   Note! Keep the part stretched during installation.

   
   

4. 
   Tightening torque: M10 , 50 Nm
   

Ensure that all clips engage.

Reinstall the removed parts in reverse order.