Installation Instruction

Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
V70 2013
V70 (08-) 2013

Instruction NoVersionPart. No.Click to download PDF-version of this Installation Instruction
306818581.231439132, 31439123, 30681835, 30721673
Upper attachment panel with hooks




IMG-257996




 
Equipment
A0000162
IMG-239660
IMG-239681

IMG-257984

IMG-213320


 
  

INTRODUCTION

  • Read through all of the instructions before starting installation.

  • Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

  • Ensure that all tools stated in the instructions are available before starting installation.

  • Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

  • In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

1
IMG-257664
 

  • Take the left-hand rail (marked LH with the holes for attachment at the upper edge) and place the rear section in the hole for the rear load securing eyelet.

  • Align it carefully and make marks for the two rear holes using a scriber.

2
IMG-257666
 

  • Align the front end of the rail carefully and make marks for the two front holes using a scriber.

  • Remove the rail.

3
IMG-257665
 


Note!

Make sure not to drill through the bracket that lies directly against the side panel's rear side.


  • Take a Ø6 mm (15/64 ") drill bit and install a drill stop of 3 mm (1/8 ").

  • Drill four holes through the side panel.

  • Remove any swarf.

4
IMG-257667
 

  • Clean the marked surfaces using a mild, not etching, cleaning agent and wipe dry.

5
IMG-257663
 

  • Remove the seven protective films from the tape on the rear side of the rail.

6
IMG-257668
 

  • Align the rail, without the tape adhering, so that the four screws can be screwed into the side panel. The screws are self tapping and there may be some resistance when installing.

  • When the screws have engaged the threads, tighten and press the tape along the entire rail.

  • Repeat all steps for the other side.

7
IMG-257669
 

  • Install the hooks by inserting them in the upper edge (1) and then downwards (2) until they lock in the rail.