Installation Instruction

Installation instructions, accessories
Volvo Car Corporation Gothenburg, Sweden
S80 2009
S80 (07-) 2009

Instruction NoVersionPart. No.Click to download PDF-version of this Installation Instruction
307723741.330739021, 30772165
Alarm, switch




 
Equipment
A0000162

IMG-233785

IMG-213320


 
  

INTRODUCTION

  • Read through all of the instructions before starting installation.

  • Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

  • Ensure that all tools stated in the instructions are available before starting installation.

  • Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

  • In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

 
1
IMG-214981
 

  • Turn the ignition key to position 0.

2
IMG-233786
 

  • Carefully prize away the panel around the gear selector lever using a weatherstrip tool. It is secured along the longitudinal sides with six catches. Start prizing in the rear edge of the panel.

3
IMG-218293
 

  • Twist / remove the panel, so that the row with switches/dummy buttons is accessible.

4
IMG-233787
 

The new switch must be fitted in the first available button location seen from the steering wheel.


Note!

The illustrations show a left-hand drive car.



Hint

In the cases where the switch shall be located furthest out in the button row, first remove the closest adjacent dummy to avoid damaging the centre console panel:


  • Remove the penultimate dummy button in the button row by carefully prizing it out using two small screwdrivers as illustrated.


    Note!

    Always prize against the surfaces that are subsequently covered by the gear selector lever panel (under the dotted line).


5
IMG-233788
 

  • Carefully prize away the dummy button where the new switch shall be fitted. Use the thumb of your other hand to counterhold at the same time.


    Note!

    Do not insert the screwdriver so far that the circuit board in the bottom is damaged.


  • Place the dummy button that shall not be re-used to one side.

 
6
IMG-218296
 

  • Install the new switch from the kit, and any dummy button.

7
IMG-233793
 

  • Reinstall the panel around the gear selector lever