Information

• Read through all of the instructions before starting installation.

• Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

• Ensure that all tools stated in the instructions are available before starting installation.

• Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

• In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

Color symbols

1. Used for focused component, the component with which you will do something.

2. Used as extra colors when you need to show or differentiate additional parts.

3. Used for attachments that are to be removed/installed. May be screws, clips, connectors, etc.

4. Used when the component is not fully removed from the vehicle but only hung to the side.

5. Used for standard tools and special tools.

6. Used as background color for vehicle components.

Removal

Open doors.

Remove the clip.

Remove the screws.

Remove the marked part.

Remove the part carefully

Remove the screws.

The part is not to be reused.

Remove the part carefully

The graphic shows the back of the component.

Remove the marked part.

The part is to be reused.

Loosen the clips.

Remove the marked part.

Accessory installation

Use special tool: T9512782, Rivet nut tool

Reset the tool.

Use hands only.

The outermost thread of the tool should be flush with the rivet nut end.

Press the tool against the surface.

Hold the tool at right angles to the surface.

Tighten to the value stated.

Measure

Use: Vernier caliper

Install components that come with the accessory kit.

Install components that come with the accessory kit.

Install component that comes with the accessory kit.

Install component that comes with the accessory kit.

Tighten the screw 2 turns.

Install component that comes with the accessory kit.

Install component that comes with the accessory kit.

Tighten the screw 2 turns.

Tighten the bolts.

Tightening torque: M10 , 50 Nm

Tighten the bolts.

Tightening torque: M10 , 50 Nm

Install component that comes with the accessory kit.

During installation, make sure that the sealing strip is correctly positioned.

Install the marked component.

Ensure that all clips engage.

Install component that comes with the accessory kit.

Install component that comes with the accessory kit.

Ensure that all clips engage.

Reinstall the removed part.

Remove the clip.

Reinstall the screws.

Reinstall the screws.

Reinstall the removed parts in reverse order.

Repeat all method steps for the other side.