Information

• Read through all of the instructions before starting installation.

• Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

• Ensure that all tools stated in the instructions are available before starting installation.

• Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

• In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

Color symbols

1. Used for focused component, the component with which you will do something.

2. Used as extra colors when you need to show or differentiate additional parts.

3. Used for attachments that are to be removed/installed. May be screws, clips, connectors, etc.

4. Used when the component is not fully removed from the vehicle but only hung to the side.

5. Used for standard tools and special tools.

6. Used as background color for vehicle components.

Removal

Note position of components.

Remove the screws.

Repeat on the other side.

Remove the screws.

Repeat on the other side.

Request the aid of a colleague for this procedure.

Remove the screws.

Tightening torque: M10 , 50 Nm

Applies to vehicles with single end pipe

Remove the screws.

Tightening torque: M8 , 24 Nm

Applies to vehicles with double end pipe

Remove the screws.

Tightening torque: M8 , 24 Nm

Repeat on the other side.

Repeat on the other side.

All vehicles

Scrape off all sealant from the flat surface.

Clean the surface.

Repeat on the other side.

Accessory installation

Install the screws.

Repeat on the other side.

Repeat on the other side.

Repeat on the other side.

Use special tool: T9997338, Extension rod

Install tow bar connector and wiring harness according to installation instruction: Towbar, Wiring and Control Unit.

Use: , Rust inhibitor, low viscosity

Repeat on the other side.

Reinstall the removed part.

Use: , Rust inhibitor

Repeat on the other side.

Install the screws.

Tightening torque: M10 , 50 Nm

Locate relevant marking.

Apply tape to the other side, opposite the marking lines.

Deburr edges

Vehicles with Diffuser

Locate relevant marking.

Apply tape to the other side, opposite the marking lines.

Deburr edges

Reinstall the removed parts in reverse order.