Information

• Read through all of the instructions before starting installation.

• Notifications and warning texts are for your safety and to minimise the risk of something breaking during installation.

• Ensure that all tools stated in the instructions are available before starting installation.

• Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps.

• In the event of any problems with the instructions or the accessory, contact your local Volvo dealer.

Further information

These installation instructions show installation on left hand drive cars.

When installing on right-hand drive cars, perform the procedures on the opposite side and/or mirrored.

Where the procedure differs, the right-hand version is also shown with text and image.

Color symbols

1. Used for focused component, the component with which you will do something.

2. Used as extra colors when you need to show or differentiate additional parts.

3. Used for attachments that are to be removed/installed. May be screws, clips, connectors, etc.

4. Used when the component is not fully removed from the vehicle but only hung to the side.

5. Used for standard tools and special tools.

6. Used as background color for vehicle components.

Removal

1. Turn on the ignition.

2. Remove the battery's negative cable.

Left hand drive vehicles

Install the screws.

Locate the pre-routed connector.

Connect the connector.

Right-hand drive vehicles

Install the screws.

Locate the pre-routed connector.

Connect the connector.

All vehicles

Remove the panel.

Remove the panel.

Repeat on the other side.

Repeat the steps when removing on opposite side.

Turn the steering wheel into neutral position.

Release the connector's catch.

Disconnect the connectors.

Detach the panel.

Remove the panel.

Repeat on the other side.

Disconnect the connector.

Disconnect the connector.

Repeat on the other side.

Loosen the screws.

Reinstall the screw.

Use hands only.

Remove the part carefully

Remove the cable harness clips.

Remove the screws.

Remove the screws.

Repeat on the other side.

Remove the screws.

Release the lock.

Accessory installation

Connect the connectors.

Install the screws.

Installation

Reinstall the removed parts in reverse order.

Accessory installation

Install the screw.

Remove the screw.

Install the screw.

Tightening torque: Steering wheel to steering column (center screw) , 48 Nm

Repeat on the other side.

Connect the connector.

Install the clip(s).

Install the cable.

Install the cable.

Connect the connectors.

Install the panel.

Connect the connectors.

Installation

Reinstall the removed parts in reverse order.

Removal

Remove the panel.

Fold the carpet aside.

Unhook the cable harness clips.

Disconnect the connector.

Remove the panel.

Disconnect the connector, if applicable.

Disconnect the connector.

Remove the screws.

Remove the screws.

Cars with automatic transmissions

All vehicles

Disconnect the connector.

Remove the screws.

Select the first free position closest to the driver.

If all locations for the switch are occupied a switch with function must be removed in priority order as illustrated.

Accessory installation

Install component that comes with the accessory kit.

Installation

Reinstall the battery's negative cable.

Reinstall the removed parts in reverse order.

Download software (application) for the accessory's function according to the service information in VIDA.

Order and download software according to: 31275377

Download software (application) for the accessory's function according to the service information in VIDA.

Order and download software according to: 31373842